Explanation
Installation Details
DipSwitch Setting
1
ON ( * )
2 3 4 5 6 7 8 1
ON ( * )
2 3 4 5 6 7 8
1
A(20A)
a b c com d e f g h com i j emerg
B(10A) C(10A) D(10A) E(10A) F(10A) G(10A) H(10A) N L
2 3 4 5 6 7 8 9 10 11 12 13
14 15 16 17 18 19 20 21 22 23 24 25 26
N
N
220V
L220V
L1 L2
220V
1
ON ( * )
2 3 4 5 6 7 8 1
ON ( * )
2 3 4 5 6 7 8
,
A B B C D E F G H
Reverse Bypass
Normal
AC E G
Curtain
Switch
Pulse
NormalNormal
C D
A:8 channel, 3 isolated group poutput: Dry
contact Relay output , each output must be
connected to the
same voltage as 220v, 110v 24v, 12v, or other
voltage.
the first A channel’s current is 20 amps, the
other seven channels’s current is 10 amps.
B: Power LN: supports 100V-240V Voltage
input , provides power for Din
C: Touch panel terminal : 8-Ch. Din modul
supports manual control panel, the terminal
can be connected to a traditional touch
switch panel, wiring can be used 1 * 1mm2
diameter of the cable ,cable length does not
exceed 10m.
D: Emergency terminal: Connect Com and
emergency terminal , the DIN modules go
into emergency status, all relay outputs will be
E: Control button: you can manually control
relays use control button . Easy to debug
when installation.
F: Output indicator LED: Feedback relay 's on
off state.
G: Pypass configuration : When DIN module
is configured to switch , Baypass configuration
let the relay output always on. Easy to debug
H: Curtain Configuration: 8 CH. DIN modules
that can be configured to four curtain
I: Pulse configuration: for C, D two channels,
when configuration to sewitch, you cnchoose
to configure as pulse output, the output will
J: Reverse configuration: for A, B two chan-
nels , when configured to switch, you can
choose to configure as invert output, the
output will revere.
When DIN module is configured to switch
,the channel supports pass-through
setting the jumper from Normal to
Bypass position, the relay output will be
forced open.
Select Configure switch or curtains,
jumpers set to Switch, corresponding to
2-way switch, jumper settings to Curtain,
When the Din module is configured to
switch, CD channel could configured
a s pulse output,the output will open 1s and
close.
When the Din module is configured to
switch, AB channel could configured
as reverse output,the output will reverse.
