Aztech HL129EP Instructions for use

MODEL
HL129EP
The following items below are included in your HL129EP package.
Package Contents
HomePlug AV2 devices are preconfigured with a common Private Network Name. Adding new HomePlug AV2 devices to an existing
network with the default Private Network Name is as easy as plugging the device into the power outlet. If you wish to have a unique
Private Network Name, simply follow the instructions below. This Easy Start Guide, the User Manual, and the HomePlug AV Utility
software is included in the Resource CD and is also downloadable on our Aztech Support Website (www.aztech.com/support).
Device Overview
STEP 1 :
In Room A, plug in your HomePlug AV2 device into the power outlet
and connect it to the modem router using an Ethernet cable.
NOTE: Ensure that your modem router’s internet connection is UP to
allow access to the internet.
STEP 2 :
In Room B plug in your other HomePlug AV/HomePlug AV2 device
into the power outlet and connect it to your computer’s Ethernet port
using an Ethernet cable.
Setting up your HomePlug AV Network
STEP 3 :
Confirm that a connection has established on both HomePlug AV/
HomePlug AV2 devices. All three LEDs (Power , Powerline , and
the corresponding Ethernet LED ) must be ON. Your Homeplug AV
Network is now ready to use and can now access Internet.
Resource CD Easy Start
Guide
Ethernet
Cable
AC
HL129EP
DEVICES ARE PLUG
AND PLAY READY.
Powerline
Activity LED
Ethernet
Activity LED 1
Power LED
Simple
Connect
Button
Reset
Button
Ethernet
Port 1 & 2
Ethernet
Activity LED 2
NOTE : You may use this AC Pass-
through as an extra power outlet.
2
B
BOTTOM VIEW
** The HL129EP is
also available in a
DEU Plug variant.

MODEL
HL129EP
Setup for an Existing Network Connection
D
If in case you have changed the Private Network Name of your
existing network, you may use the Simple Connect Button of your
HL129EP and the other devices as indicated below:
Within two minutes, press the simple connect button of
HomePlug X for TWO SECONDS.
3
Step 3
To confirm if the connection has established, check the LEDs. The Power LEDs
and the Powerline Activity LEDs on all HomePlugs would be ON.
4
Step 4
NOTES:
• When joining an existing network, you only have
to pair it to one HomePlug AV that belongs to the
existing network.
• The Ethernet Activity LED will only be lit if it is
connected to an Ethernet device (e.g. computer,
laptop, etc) through an Ethernet cable.
• To perform RESET to factory defaults, press the reset
button for 3 SECONDS.
Press the Simple Connect button of your HomePlug
X for 10 SECONDS. After you release the button, the
Power and the Ethernet LED will turn OFF and
turn ON.
1
Step 1
Press the Simple Connect Button of HomePlug AV Y for
TWO SECONDS. The Power LED will continuously blink.
If the Power LED did not blink, press the Simple Connect
button again for two seconds.
2
Step 2
Press for 3 SECONDS
to perform factory
defaul reset.
HomePlug X
(Your new HomePlug AV2)
HomePlug Y
(A HomePlug that
belongs to the existing
network)
HomePlug X
(Your new HomePlug AV2)
HomePlug Y
(A HomePlug that
belongs to the existing
network)
HomePlug X
(Your new HomePlug AV2)
HomePlug Y
(A HomePlug that
belongs to the existing
network)
HomePlug X
(Your new HomePlug AV2)
HomePlug Y
(A HomePlug that
belongs to the existing
network)