Baby Brezza One Step User manual

Instructions
Mixing Formula
1Add water
Use the markings on the
side of the pitcher to
measure your desired
amount.
2Add Formula Powder
Always follow formula
manufacturer’s powder
to water mixing ratio.
3
Tip: for powders that float
If your formula powder floats on
top of the water, use the wand
to push it down for better mixing.
Tip for mixing smaller amounts of formula:
Press the power button lightly & repeatedly to pulse mix.
This is especially helpful to minimize bubbles when the level
of formula is less than 16oz/410ml in the pitcher.
3
4
Place Lid on Pitcher
press the Power Button
Push once to turn on, allow to
mix for 1 minute, then press
again to turn off.*
Pour mixed formula
into bottles & store
them in the
refrigerator
ALWAYS follow the formula manufacturer’s instructions for mixing formula and water.
ALWAYS use boiled, cooled water or bottled water suitable for infant formula preparation.
©2018 Baby Brezza Enterprises LLC - 1 East 33rd Street, New York, NY 10016
*Some formula powders, especially hypoallergenic varieties that are inherently difficult to mix, may clump.
Warm water may help dissolve these powders. Make sure prongs on wand are completely submerged
for best mixing.

One Step™Formula Mixer Parts Installing Batteries
Removing & Installing the Mixing Wand
+
-
+
-
+
-
Battery Cover
Lid
Power Button
Mixing Wand
Pitcher
AA Batteries
(not included)
12
• Before each use, wash Pitcher, Mixing Wand and bottom of Lid in warm,
soapy water. Do not immerse the Lid in water.
Mixing Wand and Pitcher are top-rack dishwasher-safe.
• CAUTION: The lid contains electronics, please take note of the following:
- Do not immerse the Lid in water or other liquid.
- Do not place the Lid in a dishwasher.
- Note: If the lid is accidentally immersed and water gets inside, remove battery
cover & batteries, wipe with a dry cloth & allow to dry completely
before next use.
Close Battery Cover by aligning the
Open/Close indicator tabs (see below)
then rotating the Cover clockwise.
(Note location of power button)
Cleaning
Turn Battery Cover
counter-clockwise
to open.
Lift Battery Cover. 3Insert batteries
+
-
+
-
+
-
4
ClosedOpen
To remove the wand, grasp
the bottom of the wand and
pull slowly and firmly.
The Wand can be removed for cleaning.
To install the wand,
slide the hole in the end
over the axle on the bottom
of Lid and push firmly until it stops.
1 2
Please note: Rechargeable batteries will need more
frequent charging if the mixer is stored in the fridge.