Baby Trend 8807 User manual

Model # 8807
Instruction Manual
Convenience through Innovation and thoughtful design 05.07
Read all instructions BEFORE assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE USE.
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.
Sun Dance High Chair

2
Baby Trend, Inc.
1567 S. Campus Ave.
Ontario, CA 91761
Parts Hotline:
[phone]
8:00 am and 4:30 pm Pacific Standard Time
WARNINGS
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.
WARNING: Retain these instructions for future reference.
Failure to follow these instructions could result in serious injury or death.
WARNING: The tray is not designed to hold the child in the chair.
The child is to be secured by the safety harness at all times while in the
high chair.
WARNING: Prevent serious injury or death from falls or sliding
out. Always secure child in the 5-point harness system, either in the reclin-
ing, semi-reclining or upright position. The tray is not designed to hold
the child in the chair. Always keep child in view while in high chair. Never
leave child unattended. It is recommended that the high chair be used in
the upright position only by children capable of sitting upright unassisted.
See page 4 for instructions on proper use of restraint system.
* Accessory items may change the balance of the high chair and cause hazardous unstable conditions.
* Be certain the high chair is fully erect and latched in the open position before allowing the child near
the high chair.
* Use of the high chair with a child weighing more than 45 pounds will cause excessive wear and stress
on high chair.
* Never allow your high chair to be used as a toy.
* To clean use only mild household soap or detergent and warm water on a sponge or clean cloth.
* Check your high chair for loose screws, worn parts, torn material or stitching on a regular basis.
Replace or repair parts as needed.
* Discontinue use of the high chair should it malfunction or become damaged. Please contact our
customer service Parts Hotline to arrange for repair or obtain replacement parts.
Please: If you experience any difficulty with the use of our product or have a question regarding these
instructions, please contact our Customer Service Department at [phone] between the hours of
8:00 am and 4:30 pm Pacific Standard Time. Please do not return to the store as once it is returned it
cannot be resold and the materials and energy used to make it are wasted.

CONTENTS
INSTRUCTIONS
Seat
Tray
Casters
Dishwasher
safe food tray
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.
Fig. 2
Fig. 3
Fig. 5
Fig. 4
Fig. 1
Push
Depress fold
release button
3 positions
Tray release handle
3
TO ASSEMBLE FRAME
Carefully remove high chair from box. The high chair is
shipped fully assembled except for the casters and tray.
Depress the fold release buttons located on the top
of the frame and push the legs apart until fully open
and locked. (see Fig. 1)
WARNING: Always check
that the high chair is locked in the open
position before using.
TO ATTACH WHEELS
Step 1:
To attach the wheels, gently lay frame on its side.
Step 2:
Insert wheels into bottom of frame. Apply pressure
until wheels feel secure (wheels do not click into place).
(see Fig. 2)
Repeat for the remaining wheels.
WARNING: The tray is not
designed to hold the child in the chair.
The child is to be secured by the safety
harness at all times while in the high
chair.
TO ATTACH AND OPERATE TRAY
To attach the tray, line up the grooves on the bottom of
the tray with the armrests of the high chair. Squeeze the
tray release handle (see Fig. 3) and slide the tray onto the
armrest (see Fig.4). The tray has a 3-position adjustment.

Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.
Fig. 9
Fig. 6
Fig. 7
4
Fig. 8
4 positions
Squeeze up
to release
Squeeze up to release
Adjust for a
snug fit
6 positions
To adjust the position, squeeze the tray release handle
located underneath the tray and reposition the tray to the
desired position. (see Fig.5). Release tray release handle.
Check that the tray is securely locked in it’s new position.
The dishwasher safe food tray snaps onto the high chair
tray and is held in place by tabs on either side of the tray.
When installing the food tray make sure that it snaps into
place to prevent the child from removing the food tray. To
remove the food tray, carefully lift outward on the tabs on
each side.
RECLINE SEAT
Squeeze recline lever on back of the seat and adjust to
the preferred recline or upright position. (see Fig.6)
WARNING: It is recommended
that only children capable of sitting
upright unassisted use the high chair in
the upright position.
WARNING: Prevent serious
injury or death from falls or sliding out.
Always secure child in the restraint system,
either in the reclining, semi-reclining or
upright position.
TO USE SAFETY BELT
The tray is not designed to hold the child in the chair.
Always keep child in view while in high chair. Never leave
child unattended.
Step 1:
Place your child’s arms through the loops formed by the
shoulder and waist straps. Place the crotch strap between
your child’s legs. Insert the harness buckles into the center
buckle to fasten.
Step 2:
Adjust shoulder and waist straps for your child’s comfort
and safety by sliding buckles in either direction. Safety
straps are to fit snug around your child. (see Fig. 7)
TO RELEASE SAFETY BELT
Step 1:
Squeeze sides of buckles to release. (see Fig. 8)

5
Fig. 13
Lowest position Highest position
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.
Fig. 12
Fig. 10
Fig. 11
Cut out for hook
to hang tray
Hooks
WARNING: Do not adjust seat
height with child in seat. Adjust seat height
before placing your child in the high chair.
TO ADJUST SEAT HEIGHT
Step 1:
Squeeze the levers on the height adjustment bracket and adjust
to the ideal position. (see Fig. 9)
WARNING: Always check that the
height adjustment bracket is level and both
left and right sides locked before placing
child in the high chair.
TO FOLD HIGH CHAIR
The high chair may be folded with the seat in any of the
height positions. The high chair will be the most compact
with the seat in the lowest position, though the tray will only
hang with the seat in the highest position.
Step 1:
Place seat in the desired height position (see Fig. 9).
Step 2:
Place seat back in the most upright position (see Fig. 6).
Step 3:
Squeeze the tray release handle and slide the tray out.
(see Fig. 10) Hang the tray on the hooks located on the back
of the rear leg. (see Fig. 11)
Step 4:
Fold up the footrest. (see Fig. 12)
Step 5:
Depress in the release buttons (located on the sides of the
frame) and push the front legs in the direction of the rear
legs until locked. (see Fig. 13) Chair is now ready to put
away. (see Fig. 14)
TO UNFOLD HIGH CHAIR
Depress the fold release buttons located
on the top of the frame and push the legs
apart until fully open and locked.
(see Fig. 1)
WARNING:
Always check that the high
chair is locked in the open
position before using.

Fig. 14
6
STOP
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.
IF YOU EXPERIENCE ANY DIFFICULTY IN USING THIS PRODUCT, PLEASE
CONTACT OUR CUSTOMER SERVICE DEPARTMENT AT [phone] BETWEEN
THE HOURS OF 8:00AM AND 4:30PM PACIFIC STANDARD TIME FOR ASSISTANCE.
CARE AND MAINTENANCE
Dishwasher safe food tray:
The food tray is dishwasher safe to 160º degrees Fahrenheit. DO NOT
USE SCOURING PADS on the Dishwasher food tray as they will
damage the surface and the tray will become more difficult to clean.
High Chair/Tray:
Clean high chair after each, use using mild household detergents.
Please use only a soft bristle brush, sponge or cloth to surface clean
or remove particles of food. DO NOT submerge high chair tray in
water:Surface clean only.
To remove pad for washing:
Unsnap the shoulder straps from the waist belt buckle and push
through hole in pad. Push waist belt buckles and crotch strap through
holes in pad. Gently pull upward on pad to remove. Wash pad with
warm water, soap and a sponge for light stains. For a complete wash
DRY CLEAN ONLY. DO NOT MACHINE WASH OR DRY SEAT
PAD. DO NOT USE BLEACH. Hang to dry.
Replace pad and rethread safety harness in reverse order.
From time to time check your high chair for loose screws, worm parts,
torn material or stitching. Replace or repair the parts as needed.
Excessive exposure to the sun or heat could cause fading, yellowing
or warping of parts.