BaByliss MEN THE CREWCUT User manual

THE CREWCUT
7758U
SAFETY CAUTIONS
• Original instructions. Read these safety precautions
carefully before using the unit! This appliance should
only be used as described within this instruction
booklet. Please retain for future reference.
IMPORTANT CHILD SAFETY
• ALWAYS keep out of the reach of very young children
(during and after use).
• This appliance should not be used, cleaned or
maintained by children.
• Always take extra care if used on children or near
children.
• Do not use on very young children.
IMPORTANT SAFETY
• WARNING! Do not use this appliance near
bathtubs, showers, basins or other vessels
containing water.
• Do not immerse the appliance in water or other liquids.
Keep the appliance dry.
• UK Only: Do not use this appliance in the bathroom.

• OutsidetheUK:Ifusingtheapplianceinabathroom,unplug
after use as the proximity of water can be dangerous even
if the appliance is switched off. For additional protection
the installation of a residual current device (RCD) with a
rated residual operating current not exceeding 30mA is
advisable in the electrical circuit supplying the bathroom.
Ask your installer for advice.
• The appliance’s charging stand and/or adaptor must be
kept away from sources of water so that they do not fall
into the water.
• CAUTION! Keep the power cord and the appliance dry. For
appliances with a removable power supply unit, remove
the power cord before cleaning or using the appliance
under running water.
• Always inspect the appliance before use for noticeable
signs of damage. Do not use if damaged or if the appliance
has been dropped. In the event of damage contact the
Conair Customer Care Line (refer to ‘UK After Sales
Service’ section for further information).
• Do not use the appliance if the charging adaptor or lead
is damaged. In the event of damage, discontinue use
immediately. If the charging adaptor or lead is damaged,
it must be replaced by the manufacturer. Return the
appliance to the Customer Care Centre (refer to ‘UK After
Sales Service’ section for further information). No repair
must be attempted by the consumer.
• Only use the attachments supplied with this appliance.
• WARNING! For the purposes of recharging the battery,
only use the detachable charging supply unit provided

with this appliance (CA78). This symbol indicates
there is a detachable power supply for means of charging.
• Do not leave the appliance unattended when switched on.
• Do not leave the appliance plugged in for more than 24
hours.
• Unplug immediately if any problems occur during use.
• Do not place the appliance on any surface whilst in
operation.
• Special care is required when using the appliance close to
the ears, eyes and face.
• This appliance may be used by children aged from 8 and
older and people with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they
have been given supervision or instruction on the safe use
of the appliance and understand the hazards involved.
Children must not play with the appliance.
• This product contains a Lithium Ion rechargeable battery
that is not to be removed from the appliance for charging.
The batteries in this appliance are non-replaceable.
Batteries must be disposed of safely at the end of life.
Please take to a recycling centre for safe disposal. If the
battery leaks, avoid touching it and dispose of it at a
recycling centre.
• The supply terminals are not to be short circuited.
• For domestic use only.
• This product complies fully with all appropriate EU
and UK Legislation and the standards relevant to this
type and class of appliance. We are an ISO9001:2015
certied company that continually evaluates our Quality

Management System performance. If you have any
queries regarding product safety and compliance, please
contact the Conair Customer Care Line (refer to ‘UK After
Sales Service’ section).
INSTRUCTIONS FOR USE
IMPORTANT! Only use the adaptor and attachments supplied with this
appliance.
General
• Always inspect the appliance for noticeable signs of damage. Do not use
if damaged.
• Always inspect the appliance before use to ensure the clipper blades are
free from hair, debris etc.
Oiling Instructions
• For optimum cutting performance, it is highly recommended to oil the
blades after every use.
• When using the oil for the rst time, unscrew the cap and cut off the very
end of the plastic tube with a pair of scissors.
• Switch the appliance on.
• Holding the clipper gently squeeze the oil tube and apply 2 drops directly
onto the blades.
• Leave the unit on for a further few seconds to allow the oil to thoroughly
spread along the blades.
• Switch off the unit and remove any excess oil by gently dabbing with a
cloth before using on hair.
Charging the appliance
• This clipper is equipped with lithium ion batteries.
• Before using for the rst time, the appliance should be fully charged
continuously for 3 hours. This initial super-charge ensures optimum
power performance to ensure smooth fast cutting every time. Maximum
battery capacity will only be reached after 3 charging and discharging
cycles.

• Plug the charging adapter into a suitable mains power socket and switch
on at the wall. A red LED light will continuously ash indicating the clipper
is charging. When the battery is fully charged the LED light will remain on.
Note: Always charge the clipper with the ‘I/0’ switch in the OFF position.
• When the clipper is running low on charge, the charging indicator will
ash to indicate that there is less than 15% battery capacity remaining. A
full charge will provide approximately 75 minutes use. A 30 minute quick
charge will provide approximately 15 minutes use.
• If the charging light suddenly starts to ash rapidly, (more than 4 ashes
per second) then the appliance is faulty. If this happens then please stop
charging and remove the adapter from the mains and contact the Conair
Customer Care Line. (See ‘UK After Sales Service’ section for further
information).
Preserving the Batteries
• In order to maintain the optimum capacity of the rechargeable batteries,
the appliance should be fully discharged and then recharged for 3 hours
every 6 months approximately.
Comb Guides
This appliance is supplied with 5 comb guides.
Note: The trimmer can be used without any comb guides and will cut to a
length of 0.5mm.
Cutting Length Grade
3mm #1
6mm #2
9.5mm #3
13mm #4
• The appliance is also supplied with an ear taper guide. This can be used
above the ear to get a clean line.

• To attach a comb guide, ensure the appliance is switched off. Position
the comb guide over the blades and slide the sides into the slots either
side of the blades until it clicks (Fig. 1).
Fig. 1
• To remove the comb guide, place your ngers each side of the comb
guide and gently pull down and away from the unit (Fig. 2).
Preparation for Use
• For best performance, use on clean, dry hair that has been combed until
tangle-free.
• Prior to use always inspect the head for warts, moles, spots and broken
skin. Special care should be taken to avoid injury and cuts.
• Remove any head jewellery such as earrings and necklaces before use.
Note: The appliance should not be used for longer than 20 minutes when
operated from the mains.
Fig. 2

WARNING! The clipper is for use only on the head. Never use the clipper
on the face or any other area of the body.
Clipping
• Attach the comb guide length of your choice. Grade 1 = 3mm, Grade 2 =
6mm, Grade 3 = 9.5mm, Grade 4 = 13 mm.
• Switch on the clipper using the on/off sliding switch located on top of the
clipper. The blades will start to move and the green LED will illuminate.
• Starting at the nape of the neck, hold the clipper with the teeth of the
clipper pointing upwards and the comb guide at on the head. Slowly
move the clipper upwards, through the hair, and towards the front of the
head in a forward sweeping motion. Once at the front of the head, engage
the opposite blade in a backward sweeping motion to move from the front
of the head, back to the nape of the neck.
• Continue with this sweeping motion, running from the nape of the neck
to the front of the head until you reach an even length all over.
• To tidy longer hairs around the ears and neckline, simply remove the
comb guide and use the blade for neatening edges and shaping
sideburns.
• Only apply gentle pressure. Never force the clipper, if resistance is
experienced lift clipper away from the head, empty hair from the clipper
and resume clipping.
• If using on areas where there are folds of skin, ensure the skin is stretched
taught prior to cutting hair in this area.
• If you experience any discomfort stop using immediately.
• If you require a grade 0 (0.5mm) cut, the clipper can be used without a comb
guide attached.
Please Note: When you rst begin cutting your hair, you may notice that
some hair is being cut, while others are left long. This is perfectly normal,
especially if cutting slightly longer hair because hair grows in many different
directions. Continue cutting in a back and forth sweeping motion until all
the hair is cut to an even length.

Removing the blades
• The blades can be removed to aid cleaning.
• To remove the blades, hold the handle with two hands. Place your two
thumbs underneath the blades and push the blades away from the
handle (Fig. 3).
• Gently blow away any hair trapped beneath the blades.
• The blades can be rinsed under the tap. After rinsing, the blades may
need to be oiled. See ‘Oiling Instructions’.
• Be sure the blades are dry before reattaching to the clipper body.
• To reattach the blades, put the position rib of the blades into the slot
on the clipper body (Fig. 4). Then hold the handle with two hands and
press downward with both thumbs (Fig. 5). There will be a clicking
noise when the blades are securely attached when attaching the
blades.
CLEANING & MAINTENANCE
To maintain optimum performance, the appliance should be cleaned after
each use:
• Remove the comb guide after use. Rinse the comb guide under running
water and dry thoroughly before storage or use.
• Never place the clipper under running water.
• After each use ensure hair is emptied from the blade area and use the
cleaning brush to clean thoroughly.
• It is highly recommended to apply a small amount of oil to the blades
before each use.
• Wipe the outside with a damp cloth and dry thoroughly before use or
storage.
(Fig. 3) (Fig. 4) (Fig. 5)

BATTERY DISPOSAL
This appliance contains Li-ion batteries. To protect the environment this
appliance and its batteries must be disposed of safely. At the end of its life,
please take this appliance to a recycling centre, where the internal rechargeable
battery should be removed by a professional and recycled separately. For more
information about the recycling of electrical and battery operated appliances
please contact your local council ofce or your household waste disposal
service. For specic enquiries regarding the replacement of batteries in this
product please contact our Conair Customer Care Line (See ‘UK After Sales
Service’ section for further information).
UK GUARANTEE
This BaBylissMEN appliance is guaranteed for consumer use for 3 years
and is only valid within the United Kingdom.
This guarantee covers consumer use only i.e. defects occurring under
normal use within the home from date of purchase or date of delivery,
whichever is later.
If the product develops a fault due to defects in materials or manufacture
within 12 months from the date of purchase, to avoid delays and
unnecessary inconvenience, where possible please return the product to
the point of purchase for an exchange.
If the product develops a fault due to defects in materials or manufacture
after 12 months from the date of purchase, and within the guarantee
period, Conair UK After Sales Service will repair or replace the product.
Exclusions
This guarantee will no longer be valid meaning that The Conair Group Ltd
will not be liable to repair or replace your product where:
1.) The appliance has been used on a voltage supply other than that which
is marked on the product, or advised within this instruction booklet
2.) The appliance has been purchased from an unauthorised stockist*

3.) The appliance is used for professional / non domestic usage
4.) Repairs or alterations have been attempted by unauthorised persons
5.) The failure of the appliance is a direct result of misuse
6.) The failure is a result of not following the instructions for use
This guarantee does not cover any cosmetic damage due to misuse of the
product nor any damage to persons or property that occurs because of
product misuse.
*unauthorised stockists include, but are not limited to online auction sites,
private sellers and those selling second hand goods, refurbished products
etc.
Please contact the Conair Customer Care Line on 03705 133 191 (09:00 to
17:00 Monday to Friday) or e-mail ukinfo@conair.com for further information
on authorised stockists.
It is important to retain your proof of purchase. We recommend
attaching your receipt to this page.
Even where a refund may be applicable, no refund will be provided
without a valid receipt or proof of purchase, we will only be able to
offer a repair or replacement service. Please note this does not apply
if the product was purchased directly from The Conair Group Ltd.
Guarantees on replacement products run from the original purchase date
or date of delivery, whichever is later, and not from the date of replacement.
This guarantee is an additional benefit and does not affect your
statutory rights as a consumer.
If you have any queries regarding this guarantee please contact the Conair
Customer Care Line on 03705 133 191 (09:00 to 17:00 Monday to Friday)
or e-mail ukinfo@conair.com

UK AFTER SALES SERVICE
For further advice on using the appliance, contact the Conair Customer
Care Line on 03705 133191 (09:00 to 17:00 Monday to Friday) or email
your enquiry to ukinfo@conair.com.
If you should need to return your appliance to us please send it to the
following address:
Customer Care Centre
Conair Logistics
Unit 4
Revolution Park
Buckshaw Avenue
Buckshaw Village
Chorley
PR7 7DW
Please enclose your name and address, together with a copy of proof of
purchase and details of the fault.
Please note this Instruction Booklet is not the guarantee.

IB-19/148A
This manual suits for next models
1
Table of contents
Other BaByliss Hair Clipper manuals

BaByliss
BaByliss E920XE User manual

BaByliss
BaByliss MEN CARBON STEEL 7468U User manual

BaByliss
BaByliss E760XDE Operating and installation instructions

BaByliss
BaByliss E764XDE User manual

BaByliss
BaByliss E770XDE User manual

BaByliss
BaByliss GRAPHITE PRECISION E987U User manual

BaByliss
BaByliss 7785U User manual

BaByliss
BaByliss 7465E User manual

BaByliss
BaByliss POWERLIGHT PRO 7498CU User manual

BaByliss
BaByliss E702XTE User manual