BabySmile S-502 User manual

Thank you for purchasing Nasal Aspirator BabySmile S-502. To obtain the best performance
and ensure continued safety, please read entire this user's manual. This user's manual also
serves as a warranty certificate. Please keep this user's manual on file as it is required for
covered repairs.
Before Using the Unit
Getting Started
Maintenance and Storage
Troubleshooting / Warranty
Safety Precautions …………… 2
Unit Features
………………… 6
Package Contents …………… 7
Illustration of Important Parts …… 8
Set-Up
…………………………10
How to Operate the Unit……12
After Use
………………………15
Cleaning and Disinfecting the Unit …17
Assembly and Storage ………22
Malfunction and Unit Check-ups …25
Specifications …………………34
Warranty Provisions and Warranty …35
Nasal Aspirator
S-502
User's Manual Ver. 1.0

2
Safety Precautions
These safety precautions contain information intended to prevent bodily injury to the user
and to surrounding people, as well as damage to property, and must be observed at all
times.
Symbols Precautions
Warning Risk of death or serious injury from improper use
Caution Risk of injury or damage to property from improper use
Prohibited Action
Compulsory Action
General Notes
Warning
・BabySmile S-502 is a nasal aspirator designed for suctioning mucus. Please consult with
a physician or other healthcare professional before using.
・Immediately turn off the power switch and unplug the power plug from the outlet if any
abnormality occurs to the unit. Do not disassemble the unit, and contact the store you
purchased the unit.
・Before using the unit for the first time or after the unit hasn't been used for a long time,
please ensure the unit is disinfected. The unit is delivered non-sterile.
・Please ensure that suctioned materials do not exceed 11.32 fl oz (335mL) canister
capacity. Overflow of suctioned material from the canister into the pump may cause a
malfunction.
・Please consult with a physician or other healthcare professional if a long silicone tip is
used.
・Do not use the unit for anything other than the purpose described in this manual (such
as for blood drawing).
・Do not lubricate any part of the unit with grease.
・Do not operate the unit for longer than the maximum continuous operating time (Max: 5
minutes).
・Do not use the unit in a place where it may be exposed to flammable or explosive gas.
Failure to do so may cause fire or bodily injury.
・Do not disassemble or alter the unit. Failure to do so may cause fire, electric shock or
bodily injury.
・Do not block the exhaust outlet located on the rear of the unit.
・Do not wash or immerse the main unit or AC adapter in water or other liquid, as they are
not waterproof. Failure to do so may cause electric shock or a short circuit.
・Do not use if any area of body contacting the unit has a wound, inflammation or
bleeding.
・Be sure to use only the AC Adapter supplied with the unit. Using any other AC adapter
may cause a malfunction or fire.

3
Caution
・The unit can be operated at ambient temperatures of +41 to +95℉(+5 to +35℃) and
relative humidity of 75% (Max. with no ice or dew condensation.) Operating the unit
in any other operating environments may cause the unit to work incorrectly and the
patient's symptoms to get worse.
・When changing the vacuum pressure, be sure to start with lowest pressure and gradually
adjust it.
・Ensure all parts are dried thoroughly before assembly. Penetrating water or any other
liquid into the pump may cause a malfunction.
・Be sure to attach the float-shut off valve to the canister cover before using.
・Ensure the unit is placed on the horizontal and stable location.
・Do not rotate the canister when connected to the main unit. Failure to do so may cause
suctioned materials and water in the canister penetrate into the main unit, and may
cause a malfunction.
・Do not tip over the unit. Penetrating suctioned materials from the canister into the pump
may cause a malfunction.
・Do not insert fingers or objects inside the unit. Failure to do so may cause a malfunction,
electric shock or bodily injury.
・Do not use the device with a blanket or towel wrapped around. Failure to do so may
cause heat generation, electric shock or malfunction.
・Do not turnONthe power switch when the canister retains negative pressure inside.
・Do not drop or subject the unit to any strong impact. Failure to do so may cause a
breakage, electric shock or malfunction.
・Do not drop or hit the unit.
・Do not use the canister if it is damaged, cracked or broken in any way.
・Do not use accessories other than those supplied with the unit or genuine accessories
sold by Baby Health Care, Inc. Failure to do so may cause the unit to work incorrectly
and the patient's symptoms to get worse.
Power Supply
Warning
・Plug the AC Adapter into an outlet (AC 100-240V 50/60Hz 15 or higher Amp).
Using incorrect power voltage may cause electric shock, smoke emission or fire. Be sure
to use only the AC Adapter supplied with the unit.
・Do not handle the power plug or cord with wet hands.
Failure to do so may cause electric shock and result in bodily injury.
・Do not take off the AC Adapter Plug part.
Caution
・Always plug directly into a single outlet. Otherwise it may cause fire or an electrical
leakage.
・Insert the power plug into the outlet as far as it goes. A halfway inserted power plug
(imperfect contact) may cause a short circuit, electric shock and fire.
・Be sure to hold the plug when unplugging the power plug.
Unplugging by holding the cord may cause damage to the power cord, electric shock
and fire.
・Clean the power plug and the outlet on regular basis.
Accumulation of dust on the power plug and the outlet may cause heat generation and
catching fire.
・The AC Adapter can provide the power when the LED on the adapter is lit on.
Before Using the Unit

4
Caution
・Do not use the AC adapter if the cord or the power plug is damaged or if the plug
connection to the outlet is too loose. Failure to do so may cause electric shock, short
circuit or fire.
・Do not damage the power cord. Placing a heavy object or using excessive force to the
power cord may cause damage and result in electric shock or fire.
Maintenance and Storage
Warning
・Be sure to store the main unit and accessories in a clean place to prevent multiplication
of bacteria.
・Be sure to turn the power OFF and unplug the power plug from the outlet when
assembling, detaching and cleaning the unit. Failure to do so may cause electric shock
and malfunction, and result in bodily injury.
・Be sure to unplug the power plug from the outlet if the unit is not going to be used for
a long time. Failure to do so may cause accumulation of dust on the power plug and
catching fire.
・Keep out of reach of children. Failure to do so may cause a child to swallow small parts.
If a child has swallowed small parts, please contact the doctor immediately.
Caution
・Dispose of the used main unit and accessories according to the local laws and
regulations. Failure to do so may cause environmental pollution.
・Be aware not to overfill the canister with suctioned material when cleaning.
・When suctioned materials from the canister penetrate into the pump, the suctioned
material may stay in the pump and cause a malfunction. If occurred, please contact the
manufacturer or repair service center.
・Use only cold water or lukewarm water to wash the suction tube. Plastic parts are heat-
labile and using hot water may cause deformation.
・Do not use benzine, thinner or other volatile agents to clean the unit. Failure to do so
may cause a malfunction.
・Do not use or store in the following environments:
−Environments where other chemical agents are stored
−Environments where gas is generated; this unit is not explosion proof
−Environments where the unit is exposed to water
−Environments containing high percentage of dust, salt, sulfur or humidity;
using the unit in these environments may cause fire or electric shock
−Environments where the unit is exposed to unstable conditions such as
vibrations, shocks or surface inclinations. Using the unit in these environments
may cause tipping or dropping of the unit and may result in bodily injury.
−Environments where the unit is exposed to direct sunlight. Using the unit in these
environments may cause heat generation and malfunction.

5
Maintenance
Caution
・Be sure to check if the unit operates correctly and safely before using.
・Be sure to conduct daily check-ups and periodic check-ups (conducted by the user) of
the unit.
・Be sure to get annual check-ups of the unit once a year by the manufacturer or repair
service providers. Failure to do so may not maintain the performance and continued
safety of the unit.
・Be sure to clean and conduct check-ups of the unit on regular basis. To maintain the
performance and continued safety of the unit for a long time, and as well as to avoid a
sudden malfunction, please conduct daily check-ups and periodic check-ups (conducted
by the user) of the unit according to the instructions in this user's manual.
・After the unit hasn't been used for a long time, be sure to check if the unit operates
safely before using; conducting repair service check-ups may be effective.
・As the unit keeps suctioning materials in the form of mist into the tube and pump,
gradually vacuum pressure and suction flow rate are affected by suctioned materials. Be
sure to get periodic check-ups by the manufacturer or repair service providers.
Note: These check-ups are subject to fees.
Disinfecting and Use of Disinfecting Agents
Warning
・Parts should be rinsed with water thoroughly and dried completely after cleaning,
sterilizing and disinfecting. They should be stored in a clean place. Failure to do so may
cause multiplication of bacteria and infections.
Caution
・Be sure to wash parts thoroughly before disinfecting. Without removing dirt and grime
from the surface of parts may decrease the efficacy of sterilization or disinfection.
・As for dilute concentration and immersion time of disinfecting agents, be sure to follow
the instructions provided by each disinfecting agent's manufacture, and use adequate
quantity accordingly and properly. Do not use high concentration agents or leave
the parts immersed longer than required for disinfection. Failure to do so may cause
degradation of parts.
・Do not touch disinfecting agents directly or inhale vaporized gas. Failure to do so may
cause chapped hands and toxic gas inhalation.
・Do not heat an empty pot if conducting boiling disinfection. Failure to do so may cause
fire.
・Do not mix disinfectants with other disinfectants or detergents. Failure to do so may
cause degradation of disinfection efficacy and generation of harmful ingredients.
・Do not use microwave for boiling disinfection. Failure to do so may cause fire.
・Do not use disinfectants with cresol and amphoteric surface-active agents. Using these
agents may cause cracking of plastics.
Before Using the Unit

6
Unit Features
To remove the canister from the main unit, slide off
the canister cover from the main unit.
To prevent overflow of suctioned materials from the canister, the float-shut off valve is equipped
with the unit.
When the canister is filled with suctioned materials, the float closes the float-shut off valve and
stops the suction.
Note: In case of the float malfunction, always be aware that suctioned materials should not
exceed the MAX line (White Line) of canister.
Note: Be sure to keep the float clean. If suctioned materials are attached to the float, wash off
immediately.
Removing the canister
Diagram of Float-shut Off Valve
Float Cover
The float is installed
inside.
Float-Shut Off Valve
The suction is stopped
when the float closes
the valve.
Float
The float prevents the
overflow of suctioned
materials from the
canister into the main
unit.
■Making the canister cover as a part of the main unit realized a beautiful
smooth look of oneness.
■ User-friendly specifications. It's easy to connect, easy to carry and lightweight.
■ It's reliable to use. The suction power is strong enough to suction mucus.

7
Package Contents
1. Main Unit
3. Suction Tube
5. 2 pcs of Silicon Tips (small size)
6. User's Manual / Warranty
Certificate (this user's manual)
7. Comic Manual
2.
AC adapter (manufacturer-specified)
4. Silicone Tip Connector
Before Using the Unit

8
Illustration of Important Parts
Suction Tube Connector
The connector to which the
suction tube is attached.
Canister
The canister that holds suctioned materials.
The MAX line (White Line) indicates the limit
of canister capacity.
Front
Vacuum Regulator Knob
The knob that regulates the
suction power.

9
DC Connector Port
The port which the AC
adapter (manufacturer-
specified) is plugged into.
Rubber Feet
The rubber cushions
which observe and
reduce the vibrating.
Rear
Power Switch
The switch that turns
power ON and OFF.
Caution
Label
Product
Label
Canister Cover
Sliding off the canister cover
from the main unit, the canister is
removed from the main unit.
Exhaust Port
The port from which air is
exhausted to the outside of the
unit.
Before Using the Unit

10
Place the main unit on the stable location.
Connect the suction tube to the suction
tube connector.
Make sure that the vacuum regulator knob
is in the
1position.
Connect the tip connector to the other end
of suction tube connected to the main unit.
Connecting the Tube
Before Using
Set-Up
1
1
2