CAUTION
Read and follow all instructions before operating fan. Do not use fan if any
part are damaged or missing.
WARNING
1. This appliance is not intended for use by young children or infirm persons
without supervision.
2. Young children should be supervised to ensure that they do not play with
the appliance.
3. This appliance has a polarized plug (one blade is wider than the other).
To reduce the risk of electrical shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does not fit fully into the outlet,
reverse the plug. If the plug still does not fit, contact a qualified electrician.
Do not attempt to bypass this safety feature.
4. If the supply cord is damaged ,it must be replaced by manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
5. To reduce the risk of fire or electrical shock, do no use this fan with any
solid state speed control device.
6. Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
(2) Do not operate any fan with a damaged cord or plug. Discard or return
the fan to an authorized service facility for examination and/or repair.
(3) Do not run cord under carpeting. Do not cover cord with throw rugs,
runners, or similar coverings. Do not route cord under furniture or
appliances. Arrange cord away from traffic area and where it will not
be tripped over.
RULES FOR SAFE OPERATION
1. Never insert fingers, pencils, or any other object through the housing when
the fan is running. Disconnect it when moving from one location to
another.
2. Disconnect fan when moving from one location to another.
3. Disconnect fan when removing grilles for cleaning.
4. Do not leave the fan running unattended.
5. Be sure the fan is on a stable, flat surface when in operation.
6. The rules about cords and plugs are as follows:
(1) This product uses overload protection (fuse). A blown fuse indicates
an overload or short-circuit situation. If the fuse burns out, unplug the
product from the outlet. Replace the fuse as per the user servicing
instructions (follow product marking for proper fuse rating) and check
the products. If the replacement fuse blows, a short-circuit may be
present and the product should be discarded or returned to an
authorized service facility for examination and/or repair.
PARTS NAME
1 2
GUARD & FAN BLADE ASSEMBLY
1. Unscrew the spinner clockwise (or take the spinner out from the bag) and
the plastic nut counter clockwise to remove both of them. Fix the rear
guard to the motor then tighten the plastic nut again. (Fig. 1)
2. Discard PVC sleeve on shaft. Insert the blade into shaft, and make sure
the rotor shaft pin is fitted into groove of the blade. Turn the spinner
counter clockwise to tighten the blade. (Fig. 2)
3. Fasten the front guard and the rear guard by the guard clip(Fig. 3)
Clip
Fig.1 Fig.2 Fig.3
