Bailey 452 User manual

Step 1 - Corner Leg Assembly
Place the Table Top and Apron Assembly upside down on a smooth, clean surface.
Place one Corner Leg in each corner at the gap in the Apron, with the notch and starter
hole facing inside towards the Corner race.
Attach each of the four (4)Corner Legs using one (1) Lag olt, Lockwasher and
Flatwasher as shown in Figure 2. Tighten each Lag olt gradually and in sequence
between the four corners until the Lockwasher flattens out and the Corner Leg is drawn
securely into the Apron gap.
Note: tightening each corner fully before starting the next one may result in a warped
or distorted Table. If this occurs, loosen all Lag Bolts until Table flattens out, and
gradually retighten Lag Bolts in sequence.
ONTINUED ON NEXT PAGE
Model 452, 453, 456 & 457 Stationary 5 x 7 & 6 x 8
Mat Tables - Assembly Instructions
5x7 & 6x8 HARDWARE LIST:
CORNER LEGS
The following Hardware Kit is packaged
in a poly bag with the Table:
• (4) EA. # 2401 Lag olt, 3/8 x 4”
• (4) EA. # 3597 Lockwasher, 3/8
• (4) EA. #3610 SAE Flatwasher, 3/8
AILEY MANUFACTURING COMPANY • 800-321-8372 • www.baileymfg.com
Mat Table Corner Leg Assembly
orner Leg
Table Top and
Apron Assembly
#2401
Lag Bolt
orner Brace
#3597
Lockwasher
#3610
Flatwasher
Notch with
starter hole

Step 2 Center Leg Assembly
Attach the Center Support Leg race, referring to Figure 3 below. With the Table
upside down and the Corner Legs installed, position the race in the center of the
Table. Align the notches and predrilled holes in the race legs with the predrilled holes
in the Apron. Install the four (4) Flathead Wood Screws in these predrilled holes and
tighten.
After installing the Wood Screws through the Apron, attach the six (6) Angle rackets,
three (3) on each side of the Support. Determine location using predrilled holes in the
Support and Table Top. Install rackets using four (4) Hex Tapping Screws per
racket, and tighten. Ensure that the Support fits as flush against the Table Top as
possible. Adjust rackets as necessary to achieve best fit.
Step 3 Level If Required
Turn table right side up, and check for tightness and proper assembly before use. If
table needs to be leveled due to uneven flooring, use nail-on Glides on leg bottoms
where required.
Model 452, 453, 456 & 457 Stationary 5 x 7 & 6 x 8
Mat Tables - Assembly Instructions
AILEY MANUFACTURING COMPANY • 800-321-8372 • www.baileymfg.com
Mat Table Center Leg Assembly
#3290
Hex Tapping
Screws
(24) EA.
#13007
Angle Bracket
(6) EA.
#3220
Flathead Wood Screw
(4) EA.
enter Support Leg Brace
Table Top and
Apron Assembly
5x7 & 6x8 HARDWARE LIST:
CENTER LEGS
The following Hardware Kit is packaged
in a poly bag with the Table:
• (4) EA. # 3220 2” x #10 Flat Head
Wood Screw
• (4) EA. # 16625 Plastic umper
• (6) EA. # 13007 2” Angle racket
• (24) EA. #3290 3/4” x #10 Hex
Head Tapping Screws