bajaj electricals limited Page 2of 2
C. UPS / EXTERNAL POWER: 12 Volts DC Uninterrupted Power Supply is available across the terminals (12)
for various applications as described in the introduction. In case the EFL's own battery is discharged, the
product can still be used on external 12 Volts supply.
However, please ensure proper polarity (±) to avoid damage to your equipment or EFL-05.
FEATURES/SPECIFICATIONS
•Fan (2 Speeds), 254 mm sweep (10"), 1250 RPM.
•Two nos. 6 W Fluorescent Tubes.
•All functions AC/DC with auto change-over.
•12 V UPS.
•Heavy duty motor, up to 8 hours constant run.
•Heavy duty sealed maintenance-free long life battery -12 V / 8 Ah.
•Air circulator grill with knob locking.
•Backup time of UPS in absence of AC supply from mains:
Only light 15 hrs. appx.
Only fan 5 hrs. appx.
light + fan 4 hrs. appx.
•Input power: 55W on 230 Volts AC, 50Hz.
CHARGING INSTRUCTIONS
When the mains plug is connected and power is switched ON the unit will run on mains supply and also simultaneously
charge the battery, following indications will be seen:
Battery is being charged & both light and
fan are off-Charge LED (4) will be ON
Battery is fully charged & both light and
fan are off-Charge LED (4) will be Off.
Main supply trips Off, fan/light will
continue to run-Emergency LED (5) will turn ON.
Main supply is restored-Charging LED (4) will turn ON.
HOW TO REPLACE TUBES
•Remove the screws of tube housing (7).
•Take out the front cover with transparent shade.
•Replace the tubes, make sure that they make proper contact with the sockets.
•Refit the front cover.
IMPORTANT
•Please charge EFL-05 for at least 12 hours before first use.
•Switch off immediately when light goes dim or fan movement stops, to prevent battery going into deep
discharge.
•Ensure that the switches (1 to 3) are kept in Off position when not in use.
•Take care of polarity while replacing or loading battery. Wrong connection may damage UPS circuit.
•Also take care of polarity while using UPS or external power source across terminal (12).
