Balmar ARS-5 User manual

ARS-5
QUICK START GUIDE
1. Ground Input
2. Power Input
3. Ignition Input
4. Field Output
5. Bat. Temp.(+)
6. Bat. Temp.(-)
7. Stator In
8. Tach. Out
9. Alt. Temp. (+)
10. Alt. Temp. (-)
11. Dash Lamp
MC-ARS-5
Installation &
Operation Manual
www.balmar.net / Customer Service: [phone] x 1 / Technical Support [phone] x 3
SUP-0242 REVA
Positive Battery Sense
(Required for Internal Regulator Only)
Ignition
910
11
7
65
8External Regulator
Plug
Isolated Ground Terminal
MUST be connected to system ground
Positive Output
Terminal
HOUSE BATTERY
BANK
D+
1
2
3
4
+
10A
Connector 1
Connector 2
The wire diagram above shows a typical set-up for a
6-Series alternator to a ARS-5 regulator. Connector 1
is for use with the internal regulator which connects to
a Yanmar engine harness. Connector 2 is used with
the ARS-5 or MC-614 (as shown).
Alternators other than the 6-Series have similar, but
slightly different connections. If programming for
specific battery type, 12.5 volts on the battery are
necessary. Please refer to the Alternator Installation
Guide for specific connections.
FLIP OVER FOR MORE INFORMATION

www.balmar.net / Customer Service: [phone] x 1 / Technical Support [phone] x 3
Basic Programming
Programming For Battery Type
The ARS-5 features selectable programs for the following battery technologies; Flooded Deep
Cycle (FdC), Gel (gEL), AGM (AgL), Optima (OPS), factory default program (UFP).
Other Basic Programming features include programming the Belt Load Manager, programming
for Short or Long Display Mode, and programming for Alternator Failure Advisory Mode (BDL).
ARS-5 Installation & Operation Manual Available Online!
Scan QR Code
To Access
Installation &
Operation Manual
For more details on the basic
and advanced programming
features included in the
ARS-5, you can download
the full 16 page Installation &
Operation Manual.
www.balmar.net/operation-manuals
ARS-5
QUICK START GUIDE