Banzai WAVE CRUISER User manual

15733
IMPORTANT SAFETY INSTRUCTIONS.
PLEASE READ AND SAVE THESE INSTRUCTIONS BEFORE SETUP AND USE.
KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE.
FOR AGES 5-10.
ADULT SET UP IS REQUIRED.
WAVE CRUISERWAVE CRUISER
MotorizedMotorized
™

Part List
2 Inflatable Motorized WAVE CRUISER™ Body x 1
1 Controller Unit with Water Blaster x 1
4 Pipe Cover x 1 5 Repair Patch x 1 3 Propeller Unit x 1
IMPORTANT SAFETY INSTRUCTIONS.
PLEASE READ AND SAVE THESE INSTRUCTIONS BEFORE SETUP AND USE.
KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE.
FOR AGES 5-10.
ADULT SET UP IS REQUIRED.
IIII
During shipping
parts and
are shipped
assembled and
must be
separated prior
to assembling
the toy.
II
A
3
4
Press the
release latches
“A” and push
part downwards
while pulling
part
upwards.
3
4
34
BANZAI 15733 20121130 1

Safety Information
Warning!
To avoid the risk of serious injury or death:
• Only for children aged 5-10.
• Motorized WAVE CRUISER™ is intended to be
used as a toy and not as a personal flotation
device.
•
Do not hang on or stand on the Motorized Wave
Cruiser™
when playing.
• Do not use a high pressure pump to inflate.
• Do not use electric air pump if water or moisture is
present. This may result in electric stock.
• The total weight limit for the Motorized Wave
Cruiser™ is 100 lbs (45 kg), and it is designed to
hold one child.
• Use product in swimming pool only.
• Read all instructions before using Motorized Wave
Cruiser™.
• Do not shoot water blaster cannon directly at
person’s eyes or face.
• Never drive Motorized Wave Cruiser™ over the
swimmers.
• Do not dive underneath Motorized Wave Cruiser™.
• Stop using Motorized Wave Cruiser™ if there is
any damage to the propeller safety cage.
• Disregard of and not following the instructions from
manual and warnings could result in injury or
death, especially for children.
• All inflatables are temperature sensitive, therefore
never unfold or inflate in temperatures below 50°F.
• Once inflated, make sure that the product does not
come in contact with stones, gravel or other sharp
objects, which could puncture the inflatable.
• Please inflate the air chamber in correct sequence
as shown. You should be able to see some crease
at welding seams.
• To prevent premature material fatigue, refrain from
exposing the product to sunlight unnecessarily.
Over sun exposure may cause leakage.
While every attempt is made to embody the highest
degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes
all risk of injury due to use. All merchandise is sold
on this condition, which no representative of the
company can waiver or change.
Battery toys intended to be used in water must be
put in functioning in the water only after having
been assembled completely according to
instructions.
This is not a lifesaving device. Do not leave child
unattended while device is in use.
Only to be used in water in which the child can
comfortably stand up.
For use in pools only, and under adult supervision.
Repair Patch Instructions
For your convenience, a repair patch has been
included to repair holes in the inflatable section.
Do not use the patch for holes or rips on the seam.
In the event of an accidental puncture, cut out a
suitably sized patch. Make sure you round the corners
of your repair patch to avoid peeling. Make sure the
area to be patched is clean and dry. Press patch firmly
over the puncture. Do not inflate for 20 minutes.
2 BANZAI 15733 20121130

Safety Information
BATTERY WARNINGS!
Only adults should replace batteries.
• Alkaline batteries recommended.
• Do not use rechargeable batteries.
• Non-rechargeable batteries are not to be
recharged.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (nickel-cadmium) batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Batteries are to be inserted with the correct
polarity.
• Exhausted batteries are to be removed from the
toy.
• The supply terminals are not to be short-circuited.
• Please keep this information for future reference.
• Remove batteries from the product before
extended storage.
• Batteries have to be placed by respecting the
polarity indicated on the toy and on the battery. An
incorrect location can either damage the toy, either
cause leaks at the batteries level, or, to an
extreme degree, entail fire or the explosion of the
battery.
• Never throw batteries into fire, they could explode.
BANZAI 15733 20121130 3

Installing / Replacing Batteries
(Batteries not included)
1. Unscrew the top cover
on the controller unit
with a screwdriver as
shown.
2. Take out the battery
box.
3. Install 8 x 1.5V “D”
(LR20) size batteries
accordingly.
4. Place the battery box
back inside the
controller unit and
screw on the top cover
with a screwdriver.
5. To replace batteries,
make sure to remove
the Motorized WAVE
CRUISER™
from the swimming
pool, unlock the
controller unit from the
Motorized WAVE
CRUISER™ and repeat
procedures 1 to 4.
NOTE: Never install or
replace the batteries
while toy is still wet or
in the pool.
1. 2.
4. 5.
3.
Another side
4 BANZAI 15733 20121130

Setup Instructions
1.
3.
4.
2.
I
III
II
3
4
A
1. IDuring shipping,
parts 3and 4are
assembled and must be
separated prior to
assembling the toy.
II Press the release
latches “A” and push
part 3downwards
while pulling part 4
upwards.
III Separate pipe cover
from propeller pipe.
2. Placement Diagram:
Use in swimming pool
only, not on pavement
or other surfaces.
3. Roll out Motorized
Wave Cruiser™.
Inspect for holes, tears
or other damage.
4. Inflate the Motorized
Wave Cruiser™ with air
until it is halfway full.
See diagram for air
chamber locations.
NOTE: For easy air
inflation, use a manual
air pump designed
specifically for plastic
inflatable.
5 BANZAI 15733 20121130

Setup Instructions
6.
5.
7.
8.
5. NOTE: Fill inflatable with
air until the inflatable is
firm and solid. If there is
any straining at the
seams, the item is over
inflated. If any seam
begins to strain,
immediately stop inflation
and release air to reduce
the pressure until all
signs of stress on the
inflatable are gone. DO
NOT use the item if there
is straining at the seams.
Use of an over inflated
item can result in serious
injury, paralysis or death.
6. When the Motorized
Wave Cruiser™ is
partially inflated, fully
insert the pipe cover from
the top. Finish inflating
the air chambers.
7. Insert the propeller unit
into the pipe cover from
underneath the Motorized
Wave Cruiser™. You will
hear the unit click into
place when it is properly
inserted.
8. Attach the controller unit
to the top of the propeller
pipe by aligning the
connectors and pressing
the unit down until it
clicks twice.
NOTE: If you do not hear
2 clicks, the controller
unit is not properly
attached to the propeller
pipe.
For easier assembly,
push at the positions
shown.
BANZAI 15733 20121130 6

Use Instructions
How to play
1. Place the assembled
Motorized Wave Cruiser™
into the swimming pool.
2. Press and hold the right
handle’s trigger to start the
propeller; release it to stop.
3. Turn the controller unit for
steering control.
4. To shoot water blaster, hold
down the trigger on the left
handle.
5. IMPORTANT: To prevent
overheating, the Motorized
Wave Cruiser™ may
automatically shut down for
cooling after long
continuous play. The
cooling process may take
up to 1.5 hours.
NOTE:
1. This is a toy and not a life
saving flotation device. It
should not be used as
such.
2. Attention! Motorized Wave
Cruiser™ should be used
in water level no higher
than the neck of a standing
child and under adult
supervision.
3. There should be a minimum
of 6 ft (183 cm) between
the product rafts and the
swimming pool wall to
prevent the possibility of
the child falling off and
hitting his head on the edge
of the pool’s wall.
1.
2. 3.
4.
5.
7 BANZAI 15733 20121130

After Use & Storage
1. Remove the Motorized
Wave Cruiser™ from
the pool.
2. Unlock the controller
unit by pressing the
release button at the
bottom.
3. Unsnap the latches at
the pipe cover and
remove the propeller
unit.
Deflate the Motorized
Wave Cruiser™ and let
it dry thoroughly.
4. Remove all the
batteries and drain
away all the water in
the propeller unit
before storage.
NOTE: Always store
the Motorized Wave
Cruiser™ in a dry
place. Never leave in
the pool or outside
when not in use!
5. When the Motorized
Wave Cruiser™ is
completely dry,
carefully fold it up and
store in a secure
location away from
children. Do not store
indoors or in a closed
container until it is
completely dry.
NOTE: Store Motorized
Wave Cruiser™ in a
secure place, away
from children, to
prevent suffocation.
1.
2.
4.
5.
3.
BANZAI 15733 20121130 8

PLEASE RETAIN THIS INFORMATION FOR FUTURE REFERENCE.
COLORS AND CONTENTS MAY VARY.
PUTOU INDUSTRIAL AREA,
HUZHEN TOWN, BOLUO,
HUIZHOU, CHINA
ALL RIGHTS RESERVED
MADE IN CHINA
www.toysinquiry.com
DO NOT RETURN TO STORE
THIS PRODUCT CANNOT BE RETURNED
FOR A REFUND AFTER
IT HAS BEEN UNPACKED AND USED.
FOR QUESTIONS OR PROBLEMS WITH THIS PRODUCT
PLEASE EMAIL BELOW ADDRESS
FOR EXPEDITED ASSISTANCE
[e-mail]
OR
1-800-434-6178