Barco KBC1115 User manual

BENCH INSTRUCTIONS
KBC1115
KBC1120
KBC1125
KBC1151
KBC1152
KBC1153
KBC1155
KBC1156
KBC1157
KBC1161
KBC1162
KBC1163
REV#4
9/10/21

BENCH INSTRUCTIONS
HARDWARE &
TOOLS REQUIRED
FOR ASSEMBLY
2/5
NOTE: IT IS IMPORTANT TO KEEP ALL SCREWS LOOSE
DURING ASSEMBLY UNTIL ENTIRE BENCH IS ASSEMBLED
REQUIRED TOOLS
(NOT INCLUDED)
- POWER DRILL
- #2 SQUARE DRIVE
3
BENCH END
ABC-PPL1000
A
7
PLASTIC BOARDS
ABC-P0097
B
45
#10 X 2.5 SCREWS
C

BENCH INSTRUCTIONS
ASSEMBLY 3/5
C
C
A
STEP 1
Seat Assembly
Stand two outer bench ends (A) upright•
Lay a plastic board (B) over the bench•
ends (A) closest to the end
Align the holes in the plastic board with the •
predrilled holes in the bench ends
Secure the board (B) with the #10 x 2.5 screws (C)•
Repeat for each plastic board starting at the •
front seat board and working toward the back
STEP 2
Seat Assembly
Move the remaining bench end (A) to the center•
of the bench
Align the predrilled holes in the bench end with •
holes in the plastic board (B)
Secure each plastic board to the end with•
#10 x 2.5 screws (C)
INSTALL THIS BOARD FIRST
C
A
B

BENCH INSTRUCTIONS
ASSEMBLY 4/5
C
BA
STEP 3
Backrest Assembly
Hold a plastic board (B) up to the back rest portion of the bench end (A)•
Align the predrilled holes in the bench end (A) with holes in the plastic board (B)•
Secure each plastic board to the bench end with #10 x 2.5 screws (C)•
Square all components and tighten all screws•
Level board and leave 1/4 spacing between boards and secure to bench ends•
Note: If there are engraved boards, holes may be missing or not line up properly with bench ends

BENCH SPECIFICATIONS
SIDE
CONSTRUCTION MATERIALS:
Recycled Plastic
HARDWARE:
Stainless Steel
FRONT
ALL DIMENSIONS SHOWN IN INCHES
REV# 4
9/10/21
KBC1115
KBC1120
KBC1125
KBC1151
KBC1152
KBC1153
KBC1155
KBC1156
KBC1157
KBC1161
KBC1162
KBC1163
TOP
48.00 4FT BENCH
14.78
60.00 5FT BENCH
72.00 6FT BENCH
3.50
1.50
25.36
17.03
10.91
2.63