R5906150 /02 XDL6
5.6 Connecting the external safety interlocks ...........................................................................................................................57
5.7 Three phase power input configuration of the projector..............................................................................................58
5.8 Connecting the projector with the mains electricity .......................................................................................................60
5.9 Power loop through to the projector electronics ..............................................................................................................61
5.10 Connecting a UPS to the projector electronics ................................................................................................................62
6Lenses & Lens selection...........................................................................................................................................................................65
6.1 Available lenses.................................................................................................................................................................................66
6.2 Lens selection.....................................................................................................................................................................................66
6.3 Lens safety cable..............................................................................................................................................................................67
6.4 Lens installation.................................................................................................................................................................................70
6.5 Lens removal.......................................................................................................................................................................................71
7Scheimpflug.......................................................................................................................................................................................................73
7.1 Scheimpflug introduction..............................................................................................................................................................74
7.2 Scheimpflug adjustment ...............................................................................................................................................................75
7.3 Fixation of the Lens Holder front plate ..................................................................................................................................78
8Input & Communication.............................................................................................................................................................................81
8.1 Introduction...........................................................................................................................................................................................82
8.2 Local Keypad and LCD panel ....................................................................................................................................................82
8.3 Communication connections......................................................................................................................................................83
8.4 Input source connections –Quad combo input Mark II ...............................................................................................85
8.5 Input source connections –Quad DP 1.2 Input board .................................................................................................90
8.6 LED and Button indication chart...............................................................................................................................................91
8.7 Laser Status.........................................................................................................................................................................................92
9WiFi & GSM Module......................................................................................................................................................................................95
9.1 Compliance FCC...............................................................................................................................................................................96
9.2 Compliance IC....................................................................................................................................................................................96
9.3 Installation of the WiFi module ..................................................................................................................................................97
9.4 Installation of the GSM module.............................................................................................................................................. 101
10 Getting Started ............................................................................................................................................................................................. 105
10.1 Switching on the XDL .................................................................................................................................................................. 106
10.2 Switching to standby.................................................................................................................................................................... 108
10.3 Projector ON/OFF cycle explained ...................................................................................................................................... 109
10.4 Using the RCU..................................................................................................................................................................................110
10.5 Projector Address...........................................................................................................................................................................111
10.6 Quick setup via Direct access..................................................................................................................................................112
10.7 Software update ..............................................................................................................................................................................113
11 Maintenance procedures........................................................................................................................................................................117
11.1 Check the dust filters ....................................................................................................................................................................118
11.2 Vacuum cleaning of the dust filters .......................................................................................................................................119
11.3 Vacuum cleaning of the dust filters .......................................................................................................................................119
11.4 Washing and drying the dust filters...................................................................................................................................... 120
11.5 Cleaning the lens ........................................................................................................................................................................... 121
11.6 Cleaning the exterior of the projector.................................................................................................................................. 122
12 Removal and installation of the projector covers................................................................................................................ 123
12.1 Opening the front and rear cover doors ............................................................................................................................ 124
12.2 Removal of the top cover........................................................................................................................................................... 124
12.3 Removal of the side covers......................................................................................................................................................125
ASpecifications................................................................................................................................................................................................ 127
