BAREBO 962461 Operator's manual

www.barebo.com
The light can be used inside (outside), such as repair factories, workshops, building sites and so on.
Warning
• Must connect to IPX4 rated socket outlets.
• Do not disassemble the light if you are unprofessional person.
• If the external exible cable or cord of this luminaire is damaged, it should be exclusively replaced by the manufacture or
his service agent or a similar qualied person in order to avoid hazard.
• Please keep the light out of the touch of children.
• Please make sure the electricity was cut off when replacing the tube.
• Please do not use the light in the plash
Use the light in horizontal way
Use the light in vertical way
USER’S INSTRUCTION MANUAL
Art.no: 962461
Art.no: 962463

Work lamp
When the light is put on the gradient
oor in the vertical position. Please put
the cable opposite the gradient side (see
the picture) to avoid dumpage.

www.barebo.com
2. Pull out the cover
Silicon sealing
strips
NOTE: When pull out and take down the cover, it is wrong to pull out the silicon sealing strips. If the strips are pulled out, pls
take down the other board. Make sure that the strips over the both sides are almost the same length, then you can put back
the board (the side with cable)
Press the cover in
this position
Take the cover out
in this position
3. Take down the cover
5. Take down the tube
4. Take down the lamp clip
6. Assemble the light in the reverse order
Please keep the accessories carefully !
Pull out the tube
jacket in this
position
NOTE: When taking down the board ,
pls make sure that the inside rubber ring
is in the trough of the board
Tube replacing instruction
1. Take down the plastic bafe
(the side without cable)