Basalte ASANO N3 User manual

Installation Manual
ASANO N3
© 2019 basalte v2.0
1IR OUT
2S/PDIF optical input
32x 3.5 mini jack analogue input
4 Asano audio network
Before operating the unit, please read this
manual thoroughly and keep it for future
reference.
Model No. 0701-03
Caution: any changes or modifications
not expressly approved in this manual
could void your authority to operate this
equipment.
Description
Asano N3 is an input module to connect 3 sources to the Asano system. Each source supports input detection. The
module has one output to control IR devices using IR transmitter (not included).
N3 can only be used in combination with S4 and is fully controlled over the audio network. The S4’s integrated KNX
control allows you to integrate the Asano N3 in a KNX system.
LED feedback
The N3 has a feedback LED which indicates following statuses:
• Blue: standby mode
• White: at least one input is active
1
2
4
3 3
How to mount the unit
Asano N3 can be installed horizontally but can also be
mounted vertically.
Position the screws correctly, to ensure N3 is mounted
firmly to the wall with its so feet.
24 40
88
52,5
157
3,5
8
audio networkinput 3input 2input 1IR out

Installation Manual
ASANO N3
© 2019 basalte v1.0
How to install
1. Power supply
The Asano N3 can be powered using:
A) 12V DC power supply (not included)
B) PoE connection (use a network switch or PoE injector that meets IEEE 802.3af standard)
2. Audio network
Connect Asano N3 to the Asano audio network using Ethernet CAT5e cable. The network must be a dedicated
network separated from your local data network.
3. Inputs
3 Sources can be connected: 1 optical input & 2x 3,5 mini jack inputs.
The source settings can be configured in Studio.
3. IR OUT
The N3 has one IR out that can control IR devices (compatible with 0729-11 flex IR extender or 0729-12 B.link flex
triple IR extender, NOT compatible with 0729-13 B.link flex IR blaster). In combination with a multiple IR extender, all
commands will be sent to all IR devices.
The IR commands can be configured in Studio.
basalte bvba | hundelgemsesteenweg 1A | 9820 merelbeke | belgium
t [phone] | f [phone] | www.basalte.be | [email protected]
Technical data
Power: 12V DC or Power over Ethernet/PoE
DC connector: 5,0 x 2,1mm DC powerjack
Polarity: center pin positive
PoE standard: IEE802.3 af
Power consumption: 4W
Analog input sensitivity: 2V RMS
Ambient temperature:
Operation: -5°C to 45°C
Storage: -15°C to 55°C
Transport: -15°C to 55°C
Dimensions: w 157 x h 30 x d 88 mm
Weight: 0,35 kg
Max. humidity: 93% relative humidity, no moisture
condensation
Protection class: II
Type of protection: IP 20
Certification: CE