
WATER SUPPLY DEVICE
The location of the Hot and Cold water supplies establish the basis for locating the
bathtub. Use the hoses to connect the hot and cold water outlets.
INSTALLATION INTRODUCTION
1. Before installing, consideration should be given to whether the chosen location and
installation is capable of withstanding the pressure generated by the product.
2. Place the Bathtub in the chosen position, adjusting the level to make the drainage
system level and functional.
3. Tighten the screws on the corner supports to ensure that the corners of the product
are all touching the floor.
4. Install the Drain Tube
5. Install and securely accommodate cold and hot water inlet hoses, then install Mixer,
install Drain Popup.
MAINTENANCE AND CLEANING
1. Use soft cloths and general-purpose cleaners. The use of cleaners with Acetone or
Ammonia is prohibited. To disinfect, it is prohibited to use disinfectants with formalde-
hyde.
2. For dirt spots on surfaces use a soft cloth with Toothpaste to clean carefully.
3. For chrome parts with stains, use a soft cloth to clean. Avoid using abrasive cleaning
products.
4. Frequently check and clean the return net cover to prevent clogging.
SPECIAL RECOMMENDATIONS
1. Please hire qualified people to install bathtubs according to the recommended instal-
lation process.
2. When using always open cold water first and then adjust with hot water. Never open
the hot water tap first.
3. There must be adult supervision when children use the bathtub.
Customer Service: 800-500-9895
bathselect.com
2