Baumatic AS28SS User manual

AS28SS
Cooker Hood

User Manual for your Baumatic
AS28SS Cooker
Hood
90 cm Chimney Hood in Stainless Steel
NOTE: This User Instruction Manual contains important
information, including safety & installation points, which will
enable you to get the most out of your appliance. Please keep it
in a safe place so that it is easily available for future reference.
2

YOUR COOKER HOOD’S SPECIFICATIONS ….……………..………….4
IMPORTANT SAFETY INFORMATION……………………………….…5-6
CARING FOR THE ENVIRONMENT…………………………………………7
MAINTAINING AND CLEANING YOUR COOKER HOOD ……….8
INSTALLATION INSTRUCTIONS ……………………….……...….9-17
ELECTRICAL CONNECTION……………9
REPLACING THE CARBON FILTER………17
TOUCH CONTROL PANEL OPERATION..…18-19
TROUBLESHOOTING ……………………………………………20
CONDITIONS OF GUARANTEE……………………………………………21
CONTACT DETAILS…………………………………………………………..22
HT MOD 05/07/06
1
CONTENTS

Congratulations on purchasing a Baumatic Cooker
Hood!
To fully enjoy using your appliance long into the future,
please firstly familiarise yourself with its specifications,
safety advice and operational instructions included in this
manual. You will also need this manual to ensure that your
Cooker Hood has been installed properly.
DIMENSIONS
Width (canopy): 900 mm
Depth (canopy): 470 mm
Height (adjustable): 750 mm to 1180 mm
Dimensions of Chimney Section:
266 mm X 266 mm
Your stainless steel Cooker Hood is fitted with:
•High extraction capacitor motor
•Touch control operation
•Enhanced air extraction system
•Solid Stainless Steel filter cover
•Metallic grease filter
•5 Speeds and Booster
•2 Halogen Lights
•Cut off timer (15 mins)
•Service warning indicator
Extraction capacity – 750 m³/hr
Optional Extra: 1 x C1 Carbon filters for air recirculation.
Specifications of your AS28SSCooker Hood
4

Important Safety Information: Please Read this before installing & using.
o Any installation work must be
carried out by a qualified
electrician or competent person.
o The hood must be installed in
accordance with the installation
instructions and all measurements
followed.
oIf the cooker hood is installed
for use above a gas appliance then
the provision for ventilation must
be in accordance with the Gas
Safety Codes of Practice BS.6172,
BS.5440 & BS.6891 (Natural Gas)
and BS.5482 (LP Gas) 1994, the
Gas Safety (Installation & Use)
Regulations, the Building
Regulations issued by the
Department of the Environment,
the Building Standards (Scotland)
(Consolidated) Regulations issued
by the Scottish Development
Dptmt.
oIt is dangerous to alter the
specifications or to modify this
product in any way. Do not tamper
with it or attempt to alter it in the
attempt to customise it further.
oWhen installing the hood,
ensure that the following
recommended distances are being
observed between the cooker top
and the bottom of the cooker hood:
9Electric cookers:
700 mm
9Gas cookers:
700 mm
9Coal/ oil cookers:
800 mm
* NOTE - DO NOT SET YOUR
COOKER HOOD LESS THAN
700mm ABOVE YOUR COOKER!
oWhen installed between
adjoining wall cabinets,
the cabinets must not
overhang the hob.
oThe edges of the cooker
hood are sharp – be
mindful of this as you
handle your appliance,
especially during
installation and cleaning.
DO NOT CLEAN IN
BEHIND THE GREASE
FILTERS!
oIf the room where the
cooker hood is to be used
contains a fuel burning
appliance such as a
central heating boiler
then its flue must be of
the sealed or balanced
flue type.
oIf other types of flue or
appliances are fitted,
ensure that there is an
adequate supply of air in
the room.
oWhen the hood is being
used in its extractor
function, ensure that the
ducting is fire retardant
and that there are no
bends sharper than 90
degrees as this will
reduce the efficiency of
the hood.
5