Bebe Care POD 094444-393 User manual

IMPORTANT:
RETAIN FOR FUTURE REFERENCE,
READ CAREFULLY
POD HIGH CHAIR NOIR MODEL # 094444-393

2
SAFETY PRECAUTIONS
Check that all parts are engaged before placing a child in the high chair.
Always keep child in view while in high chair.
Not recommended for a child under 6mths old.
The tray is not designed to hold the child in the high chair.
ALWAYS secure your child in the restraint.Ensure that your child wears a correctly tted and adjusted harness at all times.
Only use the high chair on a secure level surface.Use the high chair on a at,even and horizontal oor.
DO NOT elevate the high chair on any structure or table.
DO NOT allow children to stand on the seat or footrest or climb into or out of the high chair.
When adjusting the tray,make sure that parts of your child’s body are clear of any moving parts.
DO NOT carry the high chair with a child in it.
To reduce the risk of injury, position the high chair away from furniture, walls, hot surfaces and liquids, window covering
cords,and electrical cords.
Position the high chair away from furniture when the high chair is not being used at a table with the tray removed.
Periodically check that all parts of the high chair are in good working order.
DO NOT use the high chair if it is damaged or broken.
The weight of the child using this high chair should not exceed 15kgs.
Promptly replace worn out or broken parts.
Please seek repair and DO NOT use high chair if it is not working correctly.
Read all instructions before assembly and use of the high chair. Keep
instructions for future use.
BEFORE ASSEMBLINGTHIS HIGH CHAIR,READ AND UNDERSTANDTHE INSTRUCTIONS.
Follow the manufacturer’s instructions
Do not leave children unattended.
The harness must always be used and correctly tted - most injuries from high chairs are
caused by falls.
Position the high chair away from solid structures and benches to avoid injuries caused by
falls and by access to dangerous items.
Be aware of the risk of an open re and other sources of strong heat in the vicinity of the
high chair.
Do not use the high chair until the child can sit up unaided.
Do not use high chair unless all components are correctly tted and adjusted.
Stop using this high chair if any part of the high chair is broken,torn or missing.
DO NOT remove harness.If harness is removed,it cannot be re-attached.If cleaning of the
harness is required,wipe with a mild soap solution.
KEEP INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE.
WARNING

3
SAFETY PRECAUTIONS
Follow the manufacturer’s instructions.
Age Group:under 36 months
Not recommended for a child under 12 months of age.
DO NOT leave children unattended.
The harness must always be used and correctly tted - most injuries from toddler chairs are caused by falls.
Position the chair away from solid structures to avoid injuries caused by falls and by access to dangerous items.
DO NOT overload the chair.
DO NOT use on an inclined surface.Use the low chair mode on a at,even and horizontal oor.
DO NOT elevate the chair on any structure or table.
Be aware of the risk of open re and other sources of strong heat, such as electric bar heaters,gas res etc.In
the vicinity of the toddler chair.
Periodically check that all parts of the chair are in good working order.
DO NOT use the low chair mode if it is damaged or broken.
DO NOT use the low chair mode unless all components are correctly tted and adjusted.
FALLING HAZARD: Prevent your child from climbing on the product.
Be aware of the risk of tilting when your child can push its feet against a table or any other structure.
Read all instructions before assembly and use of the low chair mode.
Keep instructions for future use.

4
Due to variations in the style and design of our products, the photographs and illustrations shown in this instruction
manual are generic, therefore product fabrics, colour and design may vary from images shown. CNP Brands reserves
the right to alter product specifications without notice as a result of our ongoing policy of product improvement.
Congratulations on your purchase of the Pod High Chair - Noir
This product has been designed and developed with safety, comfort
and functionality in mind. Please take the time to read this manual
carefully before using this product and keep it in a safe place for
future reference.
CONGRATULATIONS
Contents
Assembly contents list
Assembly / Operating instructions
How to care for your Pod High Chair

5
ASSEMBLY CONTENTS
Check what you have received...
You have received 1 box. Please check the contents of the box against the list
below. If anything is missing, please contact Customer Service.
In Australia, contact CNP Brands on 1300 667 137, in New
Zealand contact Wainhouse Distribution on 0800 567 5000.
Supplied loose in box:
There are no accessories recommended for use with this bebe care High Chair.
Tray with sub-tray
attached x 1x 1
x 1
Seat frame with liner
and harness pre-
assembled
Front upper leg with
pre-drilled holes x 2
x 2Rear Upper Leg
x 1
x 2
Footrest with
footrest bolts
Leg Cross Brace
x 1
Phillips Head
screwdriver required
(not supplied)
x 4Bottom Legs

6
ASSEMBLY / OPERATING INSTRUCTIONS
To fit Legs & Footrest...
1
2
3
4
Locate the two front upper legs.
Ensure they are the legs that have the pre-drilled
holes in the front of them.
Line up the screw and the hole and turn clockwise
until the leg is firm.
Ensure that the pre-drilled holes are facing the
front.
Do not over-tighten.
Repeat for opposite side.
Locating the pre-drilled holes in the front upper leg,
line up the footrest with the holes.
Insert supplied bolts and tighten with a Phillips
Head screwdriver (not supplied).
Do not over-tighten the bolts.
Repeat for opposite side.
1a.
1b.
1c.
2a.
2b.
2c.
3a.
4a.
4b.
4c.

7
ASSEMBLY / OPERATING INSTRUCTIONS
To fit Legs & Footrest Continued...
1
2
3
4
Locate the two rear upper legs.
Line up the screw and the hole and turn clockwise
until the leg is firm.
Do not over-tighten.
Repeat for opposite side.
The chair should resemble the image as shown.
Lay chair face down.
Align cross brace with upper legs, as per image
shown. Ensure silver nuts on cross brace are
facing you.
Screw one lower leg through cross brace and into
upper leg until firm.
Repeat for remaining three legs.
Ensure the feet sit flush to the floor surface before use of
the highchair.
1a.
1b.
1c.
1d.
2a.
3a.
3b.
3c.
3d.
4a.

8
ASSEMBLY / OPERATING INSTRUCTIONS
To attach Tray...
To adjust Tray...
1
1
To attach tray; align the tray with the arm rests,
push button at the front of the tray while sliding
tray along armrests to desired position.
Release button.
High chair is now ready for use.
To adjust tray; Push button at the front of the tray and
slide forward or backward to desired position.
1a.
1b.
1c.
1a.
2
3
The tray features a sub-tray, which is easily removed
by locating the lip and lifting up.
To remove tray, push button at front of tray whilst
holding the chair firmly with the other hand and slide
forward.
2a.
3a.
PLEASE NOTE! The plastic tray can be adjusted and has three positions.

9
ASSEMBLY / OPERATING INSTRUCTIONS
To use Harness Restraints..
THE HARNESS MUST ALWAYS BE USED AND CORRECTLY FITTED - MOST INJURIES FROM HIGH
CHAIRS ARE CAUSED BY FALLS.
WARNING
1To secure child in harness, push buckle (a) and (b) into the buckle housing (c)
until the buckle prongs snap into position.
Carefully adjust the harness by pulling the slider (d) until the desired fit is
achieved in the lap, shoulder and crotch strap.
To release the buckle, squeeze the top and bottom prongs until it disengages.
1a.
1b.
1c.
d d
c
ba
buckle prongs buckle prongs
sliderslider
buckle
housing
shoulder
straps
To convert to Low Chair Mode...
1The high chair can also be converted into a low chair
by inserting the four bottom legs directly into the seat
by turning clockwise until the legs are firm.
Do not over-tighten.
1a.
1b.
PLEASE NOTE! The Low Chair Mode can be used with or without the Tray.
PLEASE NOTE! DO NOT remove harness.
If harness is removed, it cannot be
re-attached. If cleaning of the harness
is required, wipe with a mild soap
solution.

10
HOW TO CARE FOR YOUR CHILDCARE HIGH CHAIR
Cleaning
Maintenance
This product has been designed and developed with safety, comfort and
functionality in mind. Please take the time to read this manual carefully before
using this product and keep it in a safe place for future reference.
To ensure the long-lasting use of your high chair, wipe down with a damp
cloth and use a mild soap solution if necessary. Do not use abrasive cleaners.
Always store product in a clean dry place.
Tray:
Wipe clean with a damp cloth and mild soap. Air dry. Do not immerse in
water.
Always check parts regularly for tightness of screws, nuts and other fasteners
– tighten or replace if required. To maintain the safety of your high chair, seek
prompt repairs for bent, torn, worn or broken parts. Use only those parts and
accessories approved by CNP Brands.
If you have any difficulties in assembling the high chair, please contact our
Service Department.
In Australia, contact CNP Brands on 1300 667 137, in New Zealand contact
Wainhouse Distribution on 0800 567 5000.

11
ABOUT US
About CNP Brands
Currently, CNP Brands boasts one of the most diverse brand portfolios with a
combination of company owned brands and distribution agreements. These
include distribution lines for Cybex, Evenflo, Good Baby, Lascal, Maclaren,
Project Nursery, Summer Infant and Yookidoo.
Our own brands, including Childcare, have gone from strength to strength in
recent years. Childcare, and our premium brand bebe care, demonstrate our
commitment to quality and continuing investment in product development.

Distributed in Australia by CNP Brands
20 Calarco Drive,
Derrimut,VIC, 3026
Customer Service 1300 667 137
W: www.cnpbrands.com.au
E: [e-mail]
F: www.facebook.com/CNPBrands
I: @cnp_baby
Distributed in New Zealand by Wainhouse
Distribution
2-6 Argyle St, Morningside,
PO Box 41-014,
St Lukes,Auckland, New Zealand
Customer Service: 0800 567 5000
E: [e-mail]