Bebe Care ZURI User manual

IMPORTANT:
RETAIN FOR FUTURE REFERENCE,
READ CAREFULLY
ZURI HI-RISE CHAIR MODEL #044310

2
Check that all parts are engaged before placing a child in the high chair.
Always keep child in view while in high chair.
Not recommended for a child under 6mths old.
The tray is not designed to hold the child in the high chair.
ALWAYS secure your child in the restraint.Ensure that your child wears a correctly tted and adjusted harness at all times.
Only use the high chair on a secure level surface.Use the high chair on a at,even and horizontal oor.
DO NOT elevate the high chair on any structure or table.
DO NOT allow children to stand on the seat or footrest or climb into or out of the high chair.
When adjusting the tray,make sure that parts of your child’s body are clear of any moving parts.
DO NOT carry the high chair with a child in it.
To reduce the risk of injury, position the high chair away from furniture, walls, hot surfaces and liquids, window covering
cords,and electrical cords.
Position the high chair away from furniture when the high chair is not being used at a table with the tray removed.
Periodically check that all parts of the high chair are in good working order.
DO NOT use the high chair if it is damaged or broken.
The product is intended for children able to sit up unaided and up to 3 years or a maximum weight of 15 kgs.
Promptly replace worn out or broken parts.
Please seek repair and DO NOT use high chair if it is not working correctly.
Read all instructions before assembly and use of the high chair. Keep
instructions for future use.
BEFORE ASSEMBLINGTHIS HIGH CHAIR,READ AND UNDERSTANDTHE INSTRUCTIONS.
FOLLOWTHE MANUFACTURER’S INSTRUCTIONS
DO NOT LEAVE CHILDREN UNATTENDED.
THE HARNESS MUST ALWAYS BE USED AND CORRECTLY FITTED - MOST INJURIES FROM
HIGH CHAIRS ARE CAUSED BY FALLS.
POSITIONTHE HIGH CHAIR AWAY FROM SOLID STRUCTURES AND BENCHESTO AVOID
INJURIES CAUSED BY FALLS AND BY ACCESSTO DANGEROUS ITEMS.
BE AWARE OFTHE RISK OF AN OPEN FIRE AND OTHER SOURCES OF STRONG HEAT IN THE
VICINITY OFTHE HIGH CHAIR.
DO NOT USE THE HIGH CHAIR UNTILTHE CHILD CAN SIT UP UNAIDED.
DO NOT USE HIGH CHAIR UNLESS ALL COMPONENTS ARE CORRECTLY FITTED AND
ADJUSTED.
STOP USING THIS HIGH CHAIR IF ANY PART OFTHE HIGH CHAIR IS BROKEN,TORN OR
MISSING.
DO NOT REMOVE HARNESS.IF HARNESS IS REMOVED, IT CANNOT BE RE-ATTACHED.IF
CLEANING OFTHE HARNESS IS REQUIRED,WIPE WITH A MILD SOAP SOLUTION.
KEEP INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE.
SAFETY PRECAUTIONS
WARNING

3
FALLING HAZARD: Prevent your child from climbing on the product.
Be aware of the risk of tilting when your child can push its feet against a table or any other structure.
FALL HAZARD: children have suffered severe head injuries including skull fractures when falling from high
chairs.falls can happen suddenly if child is not restrained properly.
• always use restraints,and adjust to t snugly.
• tray is not designed to hold child in chair.
• stay near and watch child during use.
• The child should be secured in the high chair at all times by the restraining system.
• The tray is not designed to hold the child in the chair.
• It is recommended that the high chair be used only by children capable of sitting upright unassisted.
SAFETY PRECAUTIONS

4
Contents
Assembly contents list
Assembly / Operating instructions
How to care for your Zuri Hi-Rise Chair
Congratulations on your purchase of the Zuri Hi-Rise
Chair
This product has been designed and developed with safety,
comfort and functionality in mind. Please take the time to
read this manual carefully before using this product and
keep it in a safe place for future reference.
CONGRATULATIONS
Due to variations in the style and design of our products, the photographs and illustrations shown in this instruction
manual are generic, therefore product fabrics, colour and design may vary from images shown. CNP Brands reserves
the right to alter product specifications without notice as a result of our ongoing policy of product improvement.

5
ASSEMBLY CONTENTS
Check what you have received...
You have received 1 box. Please check the contents of the
box against the list below. If anything is missing, please
contact Customer Service.
In Australia, contact CNP Brands on 1300 667 137, in New
Zealand contact Wainhouse Distribution on 0800 567 5000.
Supplied loose in box:
Seat frame with
liner and harness
pre-assembled
Bottom Leg
Cross Brace
x 1
x 1
x 2
Front upper leg
with pre-drilled
holes
Tray with sub-tray
attached
Rear upper leg
Footrest with
footrest bolts
Bottom Legs
Leg Cross Brace
with Bottom Cross
Brace Cap and
Assembly Bolt
x 1
x 4
x 1
x 2
x 2
x 1

6
ASSEMBLY CONTENTS
Check what you have received...
You have received 1 box. Please check the contents of the
box against the list below. If anything is missing, please
contact Customer Service.
In Australia, contact CNP Brands on 1300 667 137, in New
Zealand contact Wainhouse Distribution on 0800 567 5000.
Supplied loose in box:
Feet with
Washer x 1
Allen key
and spanner
x 4
There are no accessories recommended for use with this Bebecare High Chair

7
ASSEMBLY / OPERATING INSTRUCTIONS
To fit Legs and Footrest...
1
2
3
4
Locate the two front upper legs.
Ensure they are the legs that have the pre-drilled
holes in the front of them.
Line up the screw and the hole and turn clockwise
until the leg is firm.
Ensure that the pre-drilled holes are facing
the front.
Do not over-tighten.
Repeat for opposite side.
Locating the pre-drilled holes in the front upper
leg, line up the footrest with the holes.
Insert supplied bolts and tighten with a
Phillips Head screwdriver (not supplied).
Do not over-tighten the bolts.
Repeat for opposite side.
1a.
1b.
1c.
2a.
2b.
2c.
3a.
4a.
4b.
4c.

8
ASSEMBLY / OPERATING INSTRUCTIONS
To fit Legs and footest continued...
1
2
3
4
Locate the two rear upper legs.
Line up the screw and the hole and turn clockwise until
the leg is firm.
Do not over-tighten.
Repeat for opposite side.
The chair should resemble the image as shown.
Lay chair face down.
Assemble cross brace onto upper legs, as per
image shown.
Ensure the ‘T’ sticker is on the cross brace on the top.
Ensure the ‘B’ sticker is on the cross brace on the
bottom.
Ensure the silver nuts on the cross brace are facing
you.
Assemble lower legs through the cross brace
housings and into the upper legs. Tighten until firm.
Stand chair upright.
Open Bottom Leg Cross Brace and place
underneath assembled chair.
For correct assembly, ensure the ‘F’ stickers on the
feethousings correspond to the front bottom legs.
1a.
1b.
1c.
1d.
2a.
3a.
3b.
3c.
3d.
3e.
3f.
3g.
3h.
3i.
4a.
Place the feet of the four legs into the corresponding
housings of the Bottom Leg Cross Brace.

9
5Ensure the holes in the middle of the two upper cross
braces and the bottom cross brace are in alignment.
Insert Cross Brace Assembly Bolt from the underside,
through Bottom Cross Brace Cap and the two upper
cross braces.
Assemble Cross Brace Top Cap over the Bottom Cross
Brace Cap. Tighten the assembly bolt with Allen Key.
Insert one foot with one washer into the bottom of the
foot housing.
Tighten the foot using the spanner provided.
Repeat step 5d. for the remaining three feet.
Once all four feet are assembled, lightly push down on
the chair to ensure the adjustable feet are all sitting level
on the floor.
5a.
5b.
5c.
5d.
5e.
5f.
5g.
ASSEMBLY / OPERATING INSTRUCTIONS
To fit Legs and footest continued...

10
ASSEMBLY / OPERATING INSTRUCTIONS
To attach Tray...
To adjust Tray...
1
1
2
3
To attach tray; align the tray with the arm rests,
push button at the front of the tray while sliding
tray along armrests to desired position.
Release button.
High chair is now ready for use.
To adjust tray; Push button at the front of the
tray and slide forward or backward to desired
position.
The tray features a sub-tray, which is easily
removed by locating the lip and lifting up.
To remove tray, push button at front of tray whilst
holding the chair firmly with the other hand and
slide forward.
1a.
1b.
1c.
1a.
2a.
3a.
PLEASE NOTE! The plastic tray can be adjusted and has three positions.

11
ASSEMBLY / OPERATING INSTRUCTIONS
PLEASE NOTE! DO NOT remove harness. If harness is removed, it cannot be re-attached. If cleaning of the
harness is required, wipe with a mild soap solution. Use the 5-point harness at all times to ensure that baby is
safe and secure while seated.
CAUTION: The harness must be used at all times and be correctly adjusted.
Most injuries from high chairs are caused by falls.
To use the Harness...
1Place baby in the seat.
Attach shoulder straps to waist belt.
Position the crotch strap between baby’s legs and feed arms through shoulder straps.
Close buckles. You should hear a ‘click’ sound.
Adjust sliders for a snug fit ( re-adjust as baby grows).
Check to be sure the harness is securely attached by pulling it away from baby, it
should remain attached.
1a.
1b.
1c.
1d.
1e.
1f.

12
HOW TO CARE FOR YOUR BEBECARE HIGH CHAIR
Cleaning
Maintenance
This product has been designed and developed with safety, comfort and
functionality in mind. Please take the time to read this manual carefully before
using this product and keep it in a safe place for future reference.
To ensure the long-lasting use of your high chair, wipe down with a damp
cloth and use a mild soap solution if necessary. Do not use abrasive cleaners.
Always store product in a clean dry place.
Tray:
Wipe clean with a damp cloth and mild soap. Air dry. Do not immerse in
water.
Always check parts regularly for tightness of screws, nuts and other fasteners
– tighten or replace if required. To maintain the safety of your high chair, seek
prompt repairs for bent, torn, worn or broken parts. Use only those parts and
accessories approved by CNP Brands.
If you have any difficulties in assembling the high chair, please contact our
Service Department.
In Australia, contact CNP Brands on 1300 667 137, in New Zealand contact
Wainhouse Distribution on 0800 567 5000.
Warranty
For all warranty terms and conditions, please visit cnpbrands.com.au

13
ABOUT US
About CNP Brands
Currently, CNP Brands boasts one of the most diverse brand portfolios with a
combination of company owned brands and distribution agreements. These
include distribution lines for Evenflo, Good Baby, Lascal, Maclaren, Project
Nursery, Summer Infant and Yookidoo.
Our own brands, including Childcare, have gone from strength to strength in
recent years. Childcare, and our premium brand bebe care, demonstrate our
commitment to quality and continuing investment in product development.

Distributed in Australia by CNP Brands
82 Maribyrnong Street, Footscray,VIC, 3011
Customer Service 1300 667 137
W: www.cnpbrands.com.au
E: [e-mail]
F: www.facebook.com/CNPBrands
I: @cnp_baby
Distributed in New Zealand by Wainhouse
Distribution
2-6 Argyle St, Morningside,
PO Box 41-014,
St Lukes,Auckland, New Zealand
Customer Service: 0800 567 5000
E: [e-mail]