Beckett GeniSys Display Operation instructions

•The Contractors Tool
cord set plugs into
the GeniSys
communication port
for programming,
diagnostics and
service history.
•Let’s check service
history.

UP
Begin by plugging in the Contractors Tool
COM port 1

STANDBY 8:15
> 50 KOHM 115 V
FROM THIS SCREEN PRESS THE NEXT BUTTON

VIEW
HISTORY
PRESS THE SEL/YES KEY

LAST 15 CYCLES
HISTORY
PRESS THE SEL/YES KEY

1 CYCLESAGO
8:23 RUN TIME
PRESS THE NEXT KEY

1 CYCLEAGO
0:01 TO LIGHT
PRESS THE NEXT KEY

1 CYCLEAGO
500 OHMS MAX
PRESS THE NEXT KEY

1 CYCLEAGO
420 OHMS AVG
PRESS THE NEXT KEY

1 CYCLEAGO
AVG VOLTS 115V
PRESS THE NEXT KEY

1 CYCLEAGO
HEAT CALLEND
PRESS THE NEXT KEY

1 CYCLEAGO
1:12 OFFTIME
PRESS THE NEXT KEY

1 CYCLESAGO
8:23 RUN TIME
PRESS THE SEL/YES KEY TO ADVANCE TO THE
DATA FOR CYCLE NUMBER 2

•If the cycle ends in lockout, one of the following lockout reason
screens will be displayed:
1. PRE-TIME FLAME (flame seen at the end of prepurge) (check the valve)
2. DID NOT LIGHT (check for fuel, air and spark)
3. LOST FLAME (ignition budget exceeded due to too many recycles)
4. REPLACE CONTROL (motor relay check failure or software self-check failure)
•The heat cycle can end in the following ways:
1. HEAT CALL END (call for heat was satisfied)
2. PUMP PRIME (control was sent to the pump prime mode)
3. MANUAL SHUTDOWN (control button was held)
4. LOW VOLTAGE (control shut down because measured voltage during run was < 78 V)
5. RECYCLE (Losing the flame during the run cycle)