Beckett AquaSmart 7600WTM User manual

AquaSmart Wireless Temperature Module Model 7600WTM
It adds outdoor reset capability to theAquaSmart control by
overriding the control’s built-in HeatManager algorithm when
installed.

Remove power from AquaSmart, snap in AWM,
restore power.

Remove the internal cartridge containing the battery cell from the
Wireless Temperature Sensor (WTS). Press in the plastic tabs and
pull the cartridge out.

Remove the plastic insert on the battery terminal. Make sure battery
is inserted properly (see polarity mark on battery holder).

Press the WTS button once The LED should flash five times.

Option Menu
HeatManager Menu
History Menu
Circulator Menu
More Options
Economizer On/Off
Efficiency Setting
History Screens
Delay-Off Time
Delay-On Time
Circulator on TT/ZR
LWCO Menu
Pressure Menu
Wireless Menu
Using the AquaSmart’s display, navigate to Screen 1
in the wireless menu
ENTER ENTER

The screen should display the current outdoor temperature and
show that the last transmission was received within the last few
minutes.
If the OAT screen saysAS OF 18:12 AGO, press the WTS
button once.
If the value does not update, there is a problem with the connectivity
of the WTS. Move the WTS to a location closer to the AWM or with
less interference.

Navigate to screen 2. The signal strength screen indicates the
strength of the connection between the AWM and WTS.
At least 3 darkened bars are recommended for operation, with 6 or
more indicating a good connection.

Navigate to Screen 3. If the screen says “REPLACE”, the
battery needs replaced.

Navigate to Screen 4. Pressing ENTER (RESET) on this screen will
toggle the setting on and off. ON (default) indicates that the outdoor
reset algorithm will override the HeatManagerTM algorithm.

Navigate to Screen 5. Press ENTER (RESET) on this screen and
follow the on-screen instructions to change this setting. This number
specifies the outdoor temperature at which the boiler reset
temperature will be at its minimum value.

Navigate to Screen 6. Press ENTER (RESET) on this screen and
follow the on-screen instructions to change this setting. This number
specifies the outdoor temperature at which the boiler high limit
will be at its maximum value.

Navigate to Screen 7. Pressing ENTER (RESET) on this screen
will toggle the setting on and off. ON will turn the low limit of the
AquaSmart off when the outdoor temperature is above 70°F (21°C).
Turning this feature on can help to increase fuel savings. OFF
(default) will not turn the low limit off based on outdoor
temperature.

Navigate to Screen 8. Press ENTER (RESET) on this screen and
follow the on-screen instructions to change this setting. This is the
OTR’s equivalent of the HeatManager’s 20 minute kickout
function. Every 10 consecutive minutes of CFH or burner on time,
the Boost value is added to the adjusted high limit.