BEKA Schreder SOLARPOLE User manual

12V
IP 66
Please note: Tools are not included (except for 1 x T40 bit)
For detailed dimensions, please
refer to the SOLARPOLE brochure
Complete solar unit: Luminaire:
Note: Baeries to be recharged
before use
ENG FRA POR
The light source tted in this luminaire shall only be
replaced by a BEKA Schréder employee or agent or a
similar qualied person. The installation of this product
must be conducted by a qualied electrical person.
La source de lumière intégrée dans ce luminaire peut
uniquement être remplacée par un employé de
BEKA Schréder, un agent ou une autre personne qualiée.
L’installation de ce produit doit être effectuée par un
électricien qualié.
A fonte de luz montada nesta luminária só pode ser
substituída por um funcionário ou agente da BEKA Schréder
ou por prossional qualicado autorizado para o efeito. A
instalação deste produto deve ser realizada por uma pessoa
elétrica qualicada.
4.9
kg
SANS
60598
1
4
3
5
2.1 2.2
10
IK
1/8
Item List
Quantities will vary depending on the
conguration.
1. Solar panel
2.1 Baery: SuperCapacitor (x1)
2.2 Baery: Lithium-Ion (x1)
3. Panel bracket (2 x sets)
4. SuperCapacitor cable
(if applicable)
5. Luminaire
6. Spigot
43
SOLARPOLE
Post Top
6

2/8
2
345 6
Please note! Gently insert the baery into
the pole until it reaches the stopper!
1.1 Lithium-Ion 1.2 SuperCapacitor
2
1
1628-1635
4
6x
+1
-0
13 N.m.
4
6x
+1
-0
13 N.m.

3/8
87
9
Red cables!
Red cables!
13V-18V

4/8
10
11.1 Lithium-Ion 11.2 SuperCapacitor
Plug & Twist
Plug & Twist
On On
Item 5
6 N.m.
3
3x

5/8
12
13
Off
Push cables
into cavity
behind panel
1
2
Click
4
8x
+1
-0
13 N.m.

6/8
Problem Possible Cause Solution
Luminaire does not come
on at night
Or
Light does not come on
when disconnecting panel
Battery cable terminals loose Check battery terminals are tightly fastened with spanner.
Battery over discharged. Exceeded
Autonomy days.
Check battery voltage is above 11.3V. Remove battery and charge using
AC power or disconnect load for 2 days to allow batteries
to charge up fully.
Battery reached end of life. Depends
on technology and environmental
conditions.
Replace batteries with specied batteries.
Luminaire driver defective
Check polarity of luminaire is correct.
Check terminals are tightly fastened in luminaire.
Connect luminaire directly to 12V battery. If it does not energize
replace luminaire.
Luminaire does not stay
on for a complete night
Exceeded the autonomy days
Check battery voltage is above 11.3V. Remove battery and charge
using AC power or disconnect load for 2 days to allow batteries
to charge up fully.
Battery reached end of life. Depends
on technology and environmental
conditions.
Replace batteries with specied batteries.
Solar Panel has poor connection thus
batteries are not being charged fully
during day cycle.
Check terminals on charge controller that solar panel cables
are tightly fastened
Check MC4 connectors for not being securely connected
Check if MC4 connectors are crimped properly onto cable
Charger does not function.
Charger light is off.
Reversed PV connection Connect PV correctly
No fuse inserted Insert 20A fuse (75/10, 75/15, 100/15)
If panel is diconnected.
Battery fully discharged
Check battery voltage is above 11.3V. Remove battery and charge
using AC power or disconnect load for 2 days to allow batteries
to charge up fully.
Blown fuse on charger Reversed battery connection.
Battery short circuit.
1. Connect battery correctly
2. Replace fuse
Troubleshoot

7/8
Pole Buried
length (mm)
Pole Foundation dimensions
width x length x depth (mm) Backll ratio Buried Plinth strength
Standard version
6m surface mount - 900 x 900 x 900 -Class 10 Concrete
8m surface mount - 900 x 900 x 900 -Class 10 Concrete
6m buried 900 Ø600 auger Soilcrete 1:10 -
6m buried 900 900 x 900 x 900 Soilcrete 1:10 -
8m buried 1200 Ø600 auger Soilcrete 1:10 -
8m buried 1200 1000 x 1000 x 1200 Soilcrete 1:10 -
Post top version
4.6m surface mount - 700 x 700 x 466 -Class 10 Concrete
4.6m buried 700 800 x 800 x 700 Soilcrete 1:10 -
4.6m buried 700 Ø600 auger Soilcrete 1:10 -
Pole Planting Specication

Copyright © BEKA Schréder (Pty) Ltd – 13 West View Road – Olifantsfontein (South Africa) – The information, descriptions and illustrations herein are of only an indicative nature and subject to changes without notice. SOLARPOLE_PT_IS_02_2022
www.beka-schreder.co.za