Belkin Conserve Smart AV User manual

Conserve Smart AV™
Auto-Off Surge Protector
User Guide
PR# 26237
MKTG# 10WB026
DESIGNER CARINA
DATE 10/13/10 VERSION 01

UK
resettable circuit
breaker and
power switch
protected
indicator
master
socket
master
controlled
sockets
not
controlled
sockets
2 meter
power
cord
UK
2

 Conserve Smart AV Auto-Off Surge Protector
 User Guide and Warranty Information
Now you can control power
to your whole entertainment
system with the push of a
button—your TV’s power
button. The TV Master Socket
senses when your TV is on
or off and controls power to
five peripheral sockets for
your components. When you
turn your TV off, power to the
peripheral components goes
off too—including standby
power—so no energy is
wasted.For more information
and to learn about other Belkin
Conserve energy management


1 Plug a “master” device into the green Master
Socket. This will most likely be a television
or stereo amplifier. This master device will
control the four Master-Controlled Sockets.
2 Plug in any devices that do not require
constant round-the-clock power into one
of the four Master-Controlled Sockets.
Suggested use with the following devices:
DVD Player•
V C R•
Speakers/Subwoofer•
Gaming Consoles•
3 Plug in devices that need 24-hour
power into one of the two dark-gray
Not-Controlled Sockets. Suggested
use with the following devices:
DVR•
Cable Box•
Modem or Router•
3

4 Plug your Conserve Smart AV Auto-
Off Surge Protector into any wall
socket. Switch power button ON.
5 Switch on your master device (device
plugged into the green socket) as you
normally would. With a television you
might use your TV remote control or power
button located on the television set.
6 You will notice that your Master-Controlled
devices (plugged into the light-gray
sockets) will switch on automatically
after your master device is ON
4

7 After you have finished using your master
device and turned it off using your remote
or device power button, your peripheral
devices will also turn off within 30 seconds
and no longer consume any electricity.

 The “Protected” light should be on
when the power switch is turned on. If
this light goes out at any time, it either
means the circuit breaker has tripped
and should be reset, or your Surge
Protector was sacrificed to protect your
equipment and should be replaced.

Auto-calibration for maximum compatibility
with products.
- A microprocessor inside the Conserve
Smart AV determines when the Master-
Controlled Sockets turn on and off.
Intelligence built into the microprocessor
can recognize the difference between
a television powering down and a dark
scene on the screen to prevent accidental
switching of the Master-Controlled Sockets.
 1 Master Socket (Always On).
 4 Master-Controlled Sockets
(Switch on and off in response to
power state of Master Socket).
5

 2 Non-Controlled Sockets (Power is
always on at these sockets unless the
built-in circuit breaker has tripped).
Suggested use with the following devices:
 - DVRs
 - Cable Boxes
 - Modems or Routers
 Automatically shuts down Master-
Controlled Sockets when master device
is put into a standby mode to save power
 Automatically powers up Master-Controlled
Sockets when master device is activated
 Resettable circuit breaker
 Power switch to manually turn off entire unit
 “Protected” light to show when
surge circuit is active



 It is very important that your primary
device, most likely a TV, is plugged into the
Master Socket. The devices that you want
to be switched off automatically should
be plugged into the Master-Controlled
Sockets. If a device needs to stay on at all
times, make sure it is plugged into one of
the two sockets labeled “Not Controlled
 Please ensure all of the connected
plugs/extensions are inserted properly;
if they aren’t pushed in all the way,
they may not connect correctly.
 The Surge Protector may be
overloaded. Press the circuit-breaker
button to reset the circuit.


In order to fully calibrate the Conserve Smart
AV, you may need to switch o your TV after
you have switched it on for the rst time.
The Conserve Smart AV uses something
called auto-calibration. In order for this to
work properly, your TV must go through
an on and o cycle. The Conserve Smart
AV will then learn to adapt to your TV’s
unique patterns of energy consumption.

Absence of the “Protected” light indicates
the unit’s sockets are overloaded. Press
the circuit-breaker button to reset the unit.
If the light is not on after resetting the circuit
breaker, then the Surge Protector has reached
the end of its useful life. Replace the Surge
Protector to ensure proper protection.


Yes, you can use a desktop
computer as the master device.


Yes, you may decide to use your amplier
as the master device and that’s ne.
However, we do not recommend using
equipment such as a video recorder or
DVD player in the Master Socket.
6


Continuous Duty Electrical Rating: 250V~/13A/50Hz/3250W
Maximum Energy Dissipation: 1800 Joules
H-N: 600 Joules •
H-G: 600 Joules •
N-G: 600 Joules•
Clamping Voltage (3-Line): 1.5KV

To reduce the risk of electrical shock, unplug the •
unit and allow it to cool before cleaning.
Do not “daisy-chain” this product or use it with extension cords. The •
Belkin Conserve Smart AV’s power cord must be plugged directly
into an AC power source to ensure proper surge protection.
For indoor use and in dry locations only. Not for use •
with aquariums or other water-related products.
 This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged
to try to correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna.•
. Increase the separation between the equipment and receiver.•
. Connect the equipment into an socket on a circuit •
dierent from that which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.•
Belkin International, Inc., is not responsible for any interference caused
by unauthorized modications to this equipment. Such modications
could void the user’s authority to operate this equipment.


Belkin International, Inc.(“Belkin”) warrants to the original
purchaser of this Belkin product that the product shall be free
of defects in design, assembly, material, or workmanship.

Belkin warrants the Belkin product for two years.


Belkin will repair or replace, at its option, any defective product free of
charge (except for shipping charges for the product).Belkin reserves the
right to discontinue any of its products without notice, and disclaims any
limited warranty to repair or replace any such discontinued products.
In the event that Belkin is unable to repair or replace the product (for
example, because it has been discontinued), Belkin will oer either a
refund or a credit toward the purchase of another product from Belkin.
com in an amount equal to the purchase price of the product as evidenced
on the original purchase receipt as discounted by its natural use.
7


All above warranties are null and void if the Belkin product is not provided
to Belkin for inspection upon Belkin’s request at the sole expense
of the purchaser, or if Belkin determines that the Belkin product has
been improperly installed, altered in any way, or tampered with.The
Belkin Product Warranty does not protect against acts of God such as
ood, lightning, earthquake, war, vandalism, theft, normal-use wear
and tear, erosion, depletion, obsolescence, abuse, damage due to
low voltage disturbances (i.e.brownouts or sags), non-authorized
program, or system equipment modication or alteration
THIS WARRANTY CONTAINS THE SOLE WARRANTY OF BELKIN.
THERE ARE NO OTHER WARRANTIES, EXPRESSED OR, EXCEPT AS
REQUIRED BY LAW, IMPLIED, INCLUDING THE IMPLIED WARRANTY
OR CONDITION OF QUALITY, MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE, AND SUCH IMPLIED WARRANTIES, IF
ANY, ARE LIMITED IN DURATION TO THE TERM OF THIS WARRANTY.
IN NO EVENT SHALL BELKIN BE LIABLE FOR INCIDENTAL, SPECIAL,
DIRECT, INDIRECT, CONSEQUENTIAL OR MULTIPLE DAMAGES
SUCH AS, BUT NOT LIMITED TO, LOST BUSINESS OR PROFITS
ARISING OUT OF THE SALE OR USE OF ANY BELKIN PRODUCT,
EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
This warranty gives you specic legal rights, and you may also have other
rights, which may vary from jurisdiction to jurisdiction. Some jurisdictions
do not allow the exclusion or limitation of incidental, consequential,
or other damages, so the above limitations may not apply to you.

Note: This product complies with the essential requirements of the EU
Low Voltage Directive 2006/95/EC and the EMC Directive 2004/108/
EC. A copy of the European Union CE marking "Declaration of
Conformity" may be obtained at the website: www.Belkin.Com/DOC.
8

Belkin Tech Support
http://www.belkin.com/support
For more information and to learn about other
Belkin Conserve energy management products,
please go to belkin.com/conserve
8820uk00545
F7C013
Facts gathered from a study conducted by the University
of Illinois, the International Energy Agency, and the
U.S. Environmental Protection Agency.

Using electricity or driving a car does have
an eect on the environment, but by using
energy wisely we can prevent waste and
reduce carbon dioxide (CO2) emissions.
CO2 is a greenhouse gas that accumulates in the Earth’s
atmosphere, trapping heat from the sun and keeping
the planet warm. CO2 comes, in part, from the burning
of fossil fuels, such as coal and gasoline, to generate
electricity for use in our homes and to power our cars.
The amount of CO2 in our atmosphere has increased
over the past century, and the majority of scientists
questioned in a recent international study agree that
global temperatures have risen dramatically compared
with levels from the 1800s, with human activity being
a signicant contributing factor. According to the
International Energy Agency, a warmer Earth may lead
to changes in rainfall patterns, a rise in sea level, and a
wide range of impacts on plants, wildlife, and humans.
A good way to visualize CO2 is to imagine that
1kg of CO2 would ll up 1566 soda cans (0,35l),
or a box 0,8m high, 0,8m wide and 0,8m deep
Belkin Conserve products can help you
do your part to use energy wisely.
