BENOIT SYSTEMS Light Drive 2.1 User manual

USER MANUAL
LIGHT DRIVE 2.1
Foow us!
WWW.BENOITSYSTEMES.COM

Your wheelchair has been fitted with hook bars and
hooks that will allow you to set up your power add-on
very quickly.
A controller bracket at the front of your chair will hold
the joystick.
SETTING UP THE POWER ADD-ON
LOCKING THE HANDLES
PLACING THE JOYSTICK
1
2
3
1. Put the brakes on the wheelchair to make the seng up easier.
2. Point the two clutch handles towards the rear (neutral posion). If necessary, pull the
black clutch buon.
3. Hold the power add-on with its upper handle and place the axles on the hooks.
4. Make sure that the axles are posioned correctly.
1. Extend both handles to gain more force.
2. Engage both handles always beginning with the right-hand
side.
1. Place the joysck in the controller bracket at the front of
the chair.
2. Put the joysck cable alongside the seat to avoid fricon
on the wheel.
3. Adjust the joysck height through the stop.
2. 3. 4.

SETTING UP THE BATTERY
4
SETTING UP THE ANTI TIP
5
1. Place the baery rack on the baery slider on the power add-on.
2. Firmly push the baery rack unl you hear the connectors slot into each other.
Front posioning of the
baery
1. 2.
Insert the an-p into the rear handle on the power add-on
(wheel boom-facing).
Simple shi of the
clutch handles is
enough to disengage
the power add-on and
get your usual manual
wheelchair back. Disengage the left handle and turn it to the right.
Disengage the right handle and place it all the way
against the backrest.
1
2
1
For rigid-
frame
wheelchair
only
2
EXTRA
FEATURE

REMOVING THE POWER ADD-ON
RECHARGING THE BATTERY
6
7
Put the brakes on the wheelchair to make the removal easier.
1. Keep the handles engaged.
2. Remove the an-p and hang it at the designated locaon on the baery.
3. Unlock the baery with the help of the rack locking mechanism and pull it towards rear.
4. Remove the joysck and insert it in the storage bracket on the power add-on and store them
in the designated posion at the rear of the engine.
5. Place the handles in neutral posion (pull the black buon).
Li the power add-on by grabbing the upper handle. Axles should come o the hooks.
If the battery stays on the wheelchair,
connect the charger to the joysck
If the battery is removed,
connect the charger to the red connector on
the baery
Then plug the
charger into the
power supply.
Disconnect
once the load
is complete.
7 Rue du Pont, 21450 Billy Les Chanceaux FRANCE
([phone] | @[email protected]
WWW.BENOITSYSTEMES.COM
1. /2. 3. 4. /5.
Graphic design : EcloLINK - january 2021 - ©Pictures : Lionel Dupouy
READ
THE SERVICE
MANUAL
for driving, security and
maintenance
instrucons