5
g) When the device is running for a long period of time, the
surface becomes hot and a warning symbol appears on the
projection. The device switches automatically to standby
mode when it gets too hot. After the device has cooled
down, you can continue playback by pressing any key.
h) Do not allow liquids to enter into the device. Switch off the
device and disconnect it from the mains supply if liquids or
foreign substances end up inside the device. Have the unit
inspected by a technical service department.
i) Always handle the unit with care. Avoid touching the lens.
j) Never place heavy or sharp objects on the projector or the
power cable.
k) If the projector gets too hot or emits smoke, shut it down
immediately and unplug the power cable. Have your device
examined by trained professionals at a technical service
location. To prevent the spread of fire, open flames should
be kept away from the device.
l) Under the following conditions, a layer of moisture can
appear inside the device which can lead to malfunctions:
※ if the device is moved from a cold to a warm area;
※ after a cold room is heated;
※ when this device is placed in a damp room.
Proceed as follows to avoid any moisture build-up:
1. Seal this device in a plastic bag before moving it to
another room, in order for it to adapt to room conditions.
6
2. Wait one to two hours before you take the device out of
the plastic bag.
m) The device should not be used in a very dusty environment.
Dust particles and other foreign objects may damage the
unit.
n) Do not expose the device to extreme vibrations. It may
damage the internal components.
o) Do not allow children to handle the device without
supervision. The packing materials should be kept out of
children.
1-2 Repairs
Do not make any repairs to the device yourself. Improper
maintenance can result in injuries or damage to the device. Only
have your device repaired by an authorized service center.
Do not remove the type label from your device; this would void the
warranty.
1-3 Power Supply
Use only the enclosed power adapter. Check whether the mains
voltage of the power supply matches the mains voltage available at
the setup location. This equipment complies with the voltage type
specified on the unit.
