BERG Granita User manual

32
46
50 70

Fig.3
Bowl Bowl
Bowl
C
OFF
SET
OFF
SET
C
Bowl Bowl
Bowl
OFFOFF
On/ Off Switch
Bowl Button
Bowl Indicator Light
Temperature Display
Gears increase +/setting +
Gears increase - /setting -
Granita mode identification
Juice mode identification
Stirring stop identification
Illumination button
Enter or Parameter setting Button
Gears Display
760
590 950 46
68
93
950
950
590
590

Bowl Bowl
Bowl
Step1
Step2
Step3
Step4
Fig.13
Bowl Bowl
Bowl
Step1
Step2
Fig.15
Bowl Bowl
Bowl
OFF
Change the Working status of the corresponding bowl
Press the button for a second to select the working mode. There are
three working modes, Granita, juice and stirring stop. When the is on,
granita mode is selected ; when the is on , the juice mode is selected;
Under mode, it would stop stirring and the bowl would stop refrigerating？
Press the corresponding bowl button ( , or ),
the identification light of Granita mode on, then press ,
to adjust from 1st gear to 7th gear. The higher gear you adjust, the slush will
be thicker and with less water content.
Press the corresponding bowl button ( , or ),
identification light of juice pattern would illuminate, then press ,
to regulate temperature ranging from 1 Celsius degree to 7 Celsius degree.
Press for six seconds, the corresponding solenoid value will fully
open to clean for three minutes. During the time, the tap position display
shows “C”.
Press the corresponding bowl button ( , or ),
and identification light of off mode would illuminate, then it would
stop stirring and the bowl would stop refrigerating.
Step1
Step2
Step3
Step4
Fig.14
Under this working status, the solenoid value of the
corresponding bowl will be off and no refrigerant gas
will flow into, but augeris still rotating to assist the
clean. Please fill warm and clean water into the co-
rresponding bowl not exceeding the maximum level
line which is marked on the bowls.
If you are intended to perform a thorough clean or
sanitization to the machine, please ensure the ma-
chine is power off.
OFF
Step1
Step2
Fig.16
Fig.17
OFF
7
8

Cleaning preparation:
cleaning tools (bucket, hairbrush, rag)
clean water and hot water below 50 Celsius degree
neutral detergent used in food utensils
disinfectant (2% sodium hypochlorite saline solution) used in food utensils
lubricant (or Vaseline) used in food utensils
Fig.19
Fig.20
Fig.21
Fig.22
Fig.23
Fig.24
Fig.25
Fig.26

Fig.27
Fig.28
Fig.29
Fig.30
Fig.31
Fig.32
Fig.33
Fig.34
Fig.35

Fig.36
Fig.37
Fig.38
Fig.39
Fig.40
Fig.41
Fig.42
Fig.43

The Working Status is not on slush mode
The consistency has not been adjusted correctly
There is insufficient ventilation .The condenser is dirty
The machine s near source of heat
The front seal has been applied incorrectly
The consistency is adjusted too thick
The seal is not lubricated
The product is with less sugar
The bowl is dirty Turn off the machine to let the ice be melted
Clean again
Clean again
Auger seal is dirty
Auger seal is defective
The consistency is adjusted too thick
Lubricate the seal
Adjust the materials of product proportion and
do not use mellitum instead
Put the seal correctly
Install the machine at suitable place
Call a specialized person to clean the condenser
Adjust the consistency correctly
Change the working Status to slsuh mode
Granita has black stains