Bermuda BER050 User manual

PONDI MULTIPURPOSE PONDVAC, CODE: BER0509
1
Motor head. 1400 watts, rated voltage: 230V~50HZ, cable length 4.5 metres
2
ON/OFF switch
3
Discharge hose. Dia 52mm/1.5metres long
4
Dirt collecting bag to attach to the end of the discharge hose
5
Drainage hole cap (changes pond operation to wet/dry operation)
6
Locking clips
7
Suction hose plug-in connector entry hole
8
Main body collection tank, 35 litre capacity
9
Suction hose. Dia 35mm/4.5metres long
10
Suction tube extensions (4 pieces), each 48.5cm long
11
Universal nozzle for ponds, liquids, carpets and garden debris
12
Pond cleaning nozzle (transparent)
13
Filter sponge for motor (for pond and wet vacuuming)
14
4 wheels and wheel retaining clips
15
Paper Bag (for dry vacuuming)
WET INDOOR
USE
DRY USE
WET OUTDOOR USE

Thank you for purchasing the Bermuda Pondi Multipurpose Pondvac, a high-quality product based on the
newest state-of-the-art technology. The Pondi is suitable for use in garden ponds, but can also be used as a
wet and dry vacuum cleaner around the home and garden. It is not suitable for professional use, or for
emptying ponds, pools and other containers.
Please read the following instructions carefully and thoroughly. Failure to comply with these requirements
could cause serious injury and may result in product damage or failure.
1 Safety Warnings
The power supply must correspond to the product specification. If necessary, ask for information from
your local electricity supplier regarding connection regulations. Do not connect the device if these do
not meet the mentioned regulations (the voltage specification must match the operating voltage).
The device must be connected to a 30mA RCD (Residual Current Device) for prevent the possibility
of electric shock and to comply with Europe safety standards. Further information is available from
your local electricity specialist.
The device must be fully assembled before use.
Packing parts may be dangerous (e.g. plastic bags). Therefore, store away from children, domestic
animals and anyone incapable of understanding the dangers. This device is not a toy.
When cleaning a pond, the device should be positioned with a clearance of 2 metres from the waters
edge.
Never leave the device unattended.
Never carry or pull the device by the power cable.
Do not pull the device behind you by the hose during operation.
Do not cut off the plug and do not shorten the cable. Your guarantee becomes invalid if this is not
observed.
When using outdoors, ensure that the plug and socket are completely dry.
Never touch the plug with wet hands.
When the device is switched on do not hold the suction nozzle close to sensitive body parts like eyes,
ears or mouth.
Before emptying the vessel, switch off the device and remove the plug from the RCD.
Always switch off the vacuum cleaner and pull out the plug before cleaning the device. Do not
immerse the motor head (1) into water for cleaning purposes or clean with a water jet.
This device is suitable for sucking water with a maximum temperature of 35 degrees.
Replacement of the electric cable is not possible. The device must not be operated in the case of a
defective electric cable or housing.
Do not suck up flammable, explosive, poisonous or health hazardous materials with the device.
We take no responsibility for any damage to persons and objects, caused by incorrect use of the
device or by not observing these operating instructions.
2. Prior to 1st Time Use
Please read the operating instruction thoroughly.
Remove all the accessories and packages from the box and inside the main body collection tank (8).
Check before and after use that the switch is in OFF (0) position.
Always use the device with the correct filter insert suitable for the relevant application, i.e. filter
sponge (13) for wet usage, paper bag (15) for dry usage.
Attach the 4 wheel holders onto the 4 location points on the base of the main body collection tank (8)
by pushing down firmly to secure. Push the 4 wheels (14) into the location holes on the wheel
holders. The slots on the wheel holders can be used to hold the tools (see photograph on front).

3. Motor switch /operating mode
Switch position 0
Motor off
Switch position I
Manual operation (ON/OFF) for wet/dry vacuuming operation
Switch position II
Automatic operation for pond and cleaning
a) After switching on, the motor will suck for 30 seconds.
b) Motor stops after approximately 30 seconds to drain.
c) Auto Start after 30 seconds.
d) Repetition (a) and (b) to OFF (0)
4. Pond Cleaning
Please proceed as follows when using the device for pond cleaning:
Position the device at a safety clearance of 2 metres away from the waters edge.
Screw the discharge hose (3) securely onto the water discharge hole on the base of the collection
tank (8). Attach the dirt collecting bag (4) to the end of the discharge hose and place in such a way
that the water can easily flow down a drain or to a suitable location in the garden, as silt is generally
accepted as being an excellent general fertilizer. Coarse dirt will be collected in the dirt collection
bag (4). Depending on the degree of dirt, the dirt collecting bag (4) should be emptied at regular
intervals whilst cleaning the pond, and emptied and cleaned at the end of each use.
Open the two locking clips (6) on the side of the collection tank (8) and remove the motor head (1). Fit
the filter sponge (13) over the motor head (1). Tighten the cord around the motor head. Place the
motor head back onto the collection tank, ensuring the locking clips are relocated back into the
corresponding indents on the collection tank, with the electrical cable positioned on the opposite side
to the suction hose plug-in connector hole (7).
Push the plug-in connector on the suction hose (9) into the connection hole (7) on the top of the
collection tank and lock the connection by a half turn to the right.
Connect the required number of suction tube extensions (10) to the suction hose (9) and attach the
transparent suction nozzle (12) to the end of the suction tube extensions (10).
Once the above has been completed, plug the device into the RCD. Place the lance into the part of
the pond to be cleaned. To start the motor, push the switch (2) to position 11 AUTOMATIC.
After a working interval of approximately 30 seconds, the motor switches off for approximately 30
seconds in order for the water to drain out of the collection tank (8). During this time, you can
reposition your lance in a different part of the pond which requires cleaning.
The device will operate on this cycle until switched to the OFF position (0). Always remove the plug
from the RCD when the device is not in use.
Dirt and water should be thoroughly removed from the inside of the collection tank (8) at the end of
each use.

5. Indoor Wet & Dry Cleaning
Please proceed as follows when using the device for indoor wet and dry cleaning:
Screw the drain hole cap (5) securely to the base of the collection tank over the water discharge hole
(8). This will create a vacuum inside the collection tank.
For wet vacuuming, open the two locking clips (6) on the side of the collection tank (8) and remove
the motor head (1). Fit the filter sponge (13) over the motor head (1). Tighten the cord around the
motor head. Place the motor head back onto the collection tank, ensuring the locking clips are
relocated back into the corresponding indents on the collection tank, with the electrical cable
positioned on the opposite side to the suction hose plug-in connector hole (7).
For dry vacuuming, open the two locking clips (6) on the side of the collection tank (8) and remove
the motor head (1). Attach the paper bag (15) to the inside of the collection chamber over the hose
plug-in connector hole ensuring that the rubber seal on the paper bag fits over the indent on the
plug-in connector hole. Place the motor head back onto the collection tank, ensuring the locking clips
are relocated back into the corresponding indents on the collection tank, with the electrical cable
positioned on the opposite side to the suction hose plug-in connector hole (7).
Once the above has been completed, plug the device into the RCD. To turn on, push the switch (2) to
1 MANUAL. In this position, the device operates continuously.
Switch off the device after use by pushing the switch to the OFF position (0).
6. Maintenance and cleaning
Always ensure that the device is unplugged from the RCD before attempting any maintenance
or cleaning.
The Pondi requires little maintenance other than cleaning.
Thoroughly clean the collection chamber (8) and dirt collecting bag (4) with water and mild household
detergent.
Check suction hose (9), suction tube extensions (10) and drain hose (3) occasionally for possible
blocking or dirt residues and clean when necessary.
Carefully wash the filter sponge for the motor (13) with water and mild household detergent. Dry for
storage.
When storing, ensure all parts are completely dry and store in a dry, frost free area which is
inaccessible to children.
GUARANTEE
The product is guaranteed for 1 year from the date of purchase on materials and manufacturing defects. Every effort has been made
during the manufacturing process to ensure the Pondi meets the rigid quality standards. However, should you need to make a claim
under this Guarantee, please return the product to the place of purchase with the original receipt as proof of purchase. Claims brought
about by incorrect installation or operation, inadequate maintenance, the effects of frost, inexpert attempts at repair, the use of force,
wrongful acts by a third-party, overloading and foreign objects, as well as all damage to parts resulting from wear and tear, are not
covered by this guarantee. By virtue of the Product Liability Act, we are not liable for damage caused by our equipment, if this is the
result of an inexpert repair. Replacement parts can be obtained by telephoning Bermuda Customer Care on 01905 798666.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Follow us on Facebook @ Bermuda Water Gardening
EXCLUSIVELY DISTRIBUTED BY:
SOLUS GARDEN & LEISURE LIMITED, BERRY HILL INDUSTRIAL ESTATE,
DROITWICH, WORCESTERSHIRE, WR9 9AB. TEL: [phone]