Best-Rite New-Rite User manual

Best-Rite New-Rite 4' x 10'
Whiteboard Resurfacing Vinyl Roll
Instruction Manual

1Read through instructions from beginning to end before
starting this Installation. 2Clean boards surface thoroughly. 3Accurately measure the surface area to be covered with a
tape measure.
4Cut your New-Rite Surface (P-1) to exactly fit the
surface area using a utility knife. 5Test fit the New-Rite Surface.
#214 New-Rite Installation
Recommended Tools
Measuring Tape
Carpenter’s Square
Utility Knife
Roller
P1 New-Rite Surface 1 Roll
Parts List
NewRite_install 11/30/09
Use the Sponge (P-2) dipped in a
Mixture of Water and Alcohol to
clean the surface being covered and
to aid in positioning and moving the
New-Rite Surface. This mixture will
dry without effecting the bond.
R EAD T HROUGH I NSTRUCTIONS FROM BEGINNING
TO
END BEFORE STARTING THIS INSTALLATION .
N
OTE :T HIS INSTALLATION REQUIRES TWO
P EOPLE .
Start on the left hand side of the board.
Start peeling the protective backer to
expose the adhesive back.
P2 Sponge 1 EA
P3 Squeegee 1 EA
P-2
P-1

6Apply New-Rite Material.7Clean Surface
Align the New-Rite with the left side edge making sure you are straight with
the top and bottom edges.
Slowly remove the protective bacer as you start pressing the New-Rite
surface to the board. Take care not to trap air bubbles under
the surface. Slowly work to the right side of the board.
Use the Squeegee (P-3) to press the New-Rite
down and force air bubbles out.
A Roller can be used to help work out
any wrinkles or air bubbles.
Should you require assistance during
assembly, please call our Customer Service
Department
Monday - Friday 8 a.m. - 5 p.m. Central
Standard Time
Toll-Free Customer Service
1-800-749-2258
Use the Sponge (P-2) with soap
and water to clean and remove all
residue on the surface.
NewRite_install 11/30/09
P-2
P-3
OptionalRoller
WWW.MYBINDING.COM