
4
303021296694_53429E/53430E_14x21cm_22N-OEM-858_ 三滑道气模说明书
PLACEMENT:
Use on a flat, grassy area only. Do not use on pavement or
hard surfaces. Usage area should be free of rocks, bumps,
holes, sticks, etc. The water park setup location should have
a minimum distance of 10ft (305cm) from any free-standing
structures or obstructions. this include: houses, garages,
fences, trees, playground equipment, large rocks, etc.
10 ft. (305 cm)
10 ft. (305 cm)
safety area
Place on level ground and rm grass or soil to allow proper use of stakes.
Do not set up the inatable device on a slope or incline.
Stakes are to be driven straight down until the top of the stake is below ground level. Do not drive stakes at an angle.
For best holding strength, drive stakes into hard, dry soil. In loose or wet soil, or both, stake holding strength will be reduced.
The number of anchor points is the same as that of anchor stakes in the part list.
Do not use the product if wind speed exceeds 20 mph.
Do not set up in windy or rainy conditions: sudden gust of wind may lift the product off the ground.
Only the blower provided or other manufacturer specied replacement blower should be used for ination.
Use only with Ground Fault Circuit Interrupter(GFCI) receptacle.
Do not use extension cords with this product and keep the blower and power cord away from water.
Product shall be fully inated and anchored before use.
After ination, the blower should run continuously while children are playing.
ASSEMBLY
IMPORTANT: Drain the water park of all water to prevent mold and mildew. Product should be completely dry before storage. Do not fold
and store water park if any moisture remains.
IMPORTANT: All children must exit the water park before deation or draining.
1. Turn off the garden hose and disconnect it from the tube.
2. Turn off the blower motor and unplug it from the outlet. Move the blower to dry ground if it appears that it will get wet from draining water.
3. Open the water valve and drain the water.
4. Remove stakes and drag water park away from the drained water to a dry area.
5. Re-stake the water park and blower, tie the ination tube to the blower, then reconnect and power up the blower.
6. Leave the water park inated until all remaining water has evaporated and the water park is dry.
7. Once water park is completely dry, turn off the blower and unpulg it from the outlet.
8. Remove and drain the hose assembly from the Water park. Untie the drawstring from the short outlet tube and allow the water park to
fully deate. Remove the hose assembly and wrap it up with no kinks.
WARNING
• Constant, competent adult supervision of children and other young users is required at all times in front of the device where all parts of
play areas can be seen.
• Keep the area around the product clean, and clear of objects, to prevent slips and falls.
• Always check all anchors before and during use.
• To prevent electric shock, do not clean the blower with water.
• Children should not wear loose or baggy clothing, scarves, hoods or clothing with drawstrings or long cords while playing in this product.
• Children must remove helmets, loose clothing, scarves, headgear, shoes and glasses, as well as any sharp or hard objects from their
pockets, as they may puncture the bounding surface.
• Separation of larger children from smaller children. Do not allow children to play together who are unevenly matched in weight and height.
• Do not allow users to climb or hang on containment walls.
• Do not allow users to do somersaults or rough play.
• Do not allow food, drink or gum inside unit.
• Children must not slide down head rst on their stomach.
• Keep pets away from product.
• Do not attach items to the inatable device that are not specically designed for use with the inatable device, such as, but not limited to,
jump ropes, clothesline, pet leashes, cables and chain as they have the potential to cause a strangulation hazard.
MAINTENANCE OF WATER PARK
1. To keep the product clean: wipe the inatable device using a dry cloth or a cloth dampened with a neutral, non-ammable, non-toxic
cleaning and sanitizing solution or pure water.
2. If applicable, remove water and debris from pocket steps after each play cycle.
3. As an outdoor product, the inatable device is subject to wear and deterioration. Inspect for signs of fabric failure; weak or torn surface
must be repaired promptly.
MAINTENANCE OF AIR BLOWER
The source of electrical supply must be disconnected prior to any servicing or cleaning.
1. Use a dry cloth to gently clean all surfaces.
2. Store in a cool, dry place and out of children’s reach.
DRAINING & DEFLATION
IMPORTANT:
1. Never store the water park when wet. Allow to dry before folding for storage. Follow all previous instructions each use.
2. Store park in a secure place away from children to prevent suffocation hazards. Never leave either the park or the blower outside
when not in use.
3. Please place it the dry and ventilated position where is not sour, not alkali and not corrosive gases. After having used it in outdoors,
you should place it in a dry and ventilated room in time. Do not let water into the air-blower.
STROAGE