Biem Butter Sprayer User manual
Ready
Please scan for customer
service, FAQ’s, and more
information about biēm
Power button
stops blinking
Quick Start Guide
To use biēm:
Remove
Cap
Replace
Cap
Turn on Butter
Melting
Ready Spray
Slow
Blink
Insert
Butter
Recharging the battery:
Lid
Press here
to spray
Trigger
Battery
Door
Ready-to-Spray
Indicator
On/OButton
Butter melting
Indicator
Battery
Indicator
www.biēmspray.com
Patent Pending
Press
Press
here to
spray
Ready-to-spray
indicator is on
Butter
1
6
57
2 3 4
Troubleshooting: Does not spray
Warranty
Cleaning
Wait until ready; both
lights are solid blue
Battery light is red
Charge the battery
Cap is not on correctly
Remove and replace
Butter is melting
More about biēm
Top light is red;
butter is out
Butter
Add butter
Please scan for customer
service, FAQs, and more
information about biēm
w w w. biems p r a y. c o m
Water
5 sec.
PressPress
• Never submerge your biēm. Also, biēm cannot
go in the dishwasher. Doing so will void the
warranty.
• Clean the biēm by running the cleaning cycle
(below) and wiping the outside with a cloth
dampened with water and mild dishwashing
soap.
• While butter will stay fresh in the biēm if used
regularly and stored on the counter, the biēm can
also be stored in the refrigerator. Note that initial
start time may be longer if it has been refrigerated.
• Do not store biēm in the freezer.
• Always store biēm upright.
biēm will repair or replace (at our option) your unit free of
charge for 12 months from the date of purchase if the unit is
defective in workmanship or materials. To claim your
repair/replacement, the product must be returned to biēm
along with proof of purchase. In the absence of the purchase
receipt, the warranty will be 12 months from the date of
manufacture.
This warranty does not apply to normal wear or damage from
misuse, abuse, improper storage and handling, installation,
accident, unauthorized repair or alteration.
If you experience a problem that is not noted in this guide, our
Consumer Relations Team may have a simple solution
to your problem.
Please contact our Consumer Relations Team at
www.biemspray.com for details.
Fill biēm 2/3 up
with hot water,
add 1 drop of
dish soap and
shake for a few
seconds.
Turn biēm on
by pressing
the on/off
button.
Press and hold
the on/off button
for 5 seconds.
Top light and
power lights
turn dark blue.
Spray for 10
seconds then
rinse with clean
water. Spray
again and
empty water.
Both lights are on,
but only air is
spraying
Remove lid and block
the nozzle with your
finger until bubbles are
seen in the chamber.
