Big Agnes Three Wire Bivy Sack Manual

eVENT shell closed Mesh bug netting closed
1. Remove contents from stuff sack and lay the bivy out on the ground
2. Assemble the pole, it will form a cross shape - notice there is one section of the pole with
a longer side and a shorter side (relative to the plastic hub piece where all four sections
of the poles meet)
3. Insert the longest pole section into the hole located at the top center of the hood, under the visor.
4. Fit the end of that pole into the reflective webbing pocket inside the hood located at the
seam between the floor and the hood. Wrap the Velcro piece around the pole for more stability.
5. Pull the visor over the opposite end of the pole (the shorter end) and fit the end of the pole
into the webbing pocket located at the edge of the visor.
6. Insert one of the two remaining free ends of the pole into its respective grommet at the
bottom, side of the hood, making sure the pole threads through the opening (not in front
of it) of the visor and into the grommet.
7. Repeat step 6 with the remaining free pole section.
8. Stake out the bivy for maximum stability and ventilation.
Separate 6", large diameter pole segment included for emergency field repair.
Slide repair pole over the break to act as a splint.
• Our shelters are easy to set up but we suggest you practice once at home before using them
for the first time to avoid fumbling around in the dark.
• Before pitching the bivy, clear campsite of debris that may pierce the floor.
• Big Agnes bivy sacks don't require stakes, but we recommend staking them out to increase
space and keep your bivy from becoming a tumbleweed.
• Hang onto your stuff sacks while pitching or they'll blow away and create backcountry litter.
THREE WIRE BIVY SETUP INSTRUCTIONS
HELPFUL HINTS
Cut here to remove. Do Not Tear!
k
bivysetupinst08 11/8/07 12:23 PM Page 1

Storage
Always make sure your tent is dry and free of debris before storing. Stuff or fold your tent a dif-
ferent way each time to avoid permanent creases. Store in a cool, dry place. Never leave your tent
in very hot temperatures (such as a car trunk), as it will damage the material coatings. Storing your
tent damp can result in mildew growth, which may cause your tent to smell, leak or delaminate.
Mildew damage is not covered under warranty.
Cleaning
For light cleaning, you can sponge the tent with warm water. If it’s necessary to wash the entire
tent, always use cleaners recommended specifically for tents. We recommend McNett Mirazyme
cleaner, or Nikwax Tech Wash. Do not dry clean or machine-wash your tent. Detergents and dry
cleaning solvents will damage the fabric and ruin waterproofing. Never use hot water, bleach, liq-
uid detergents or dishwashing liquids.
Seam Sealing
Seam tape alone is durable enough to prevent water leakage. Any seams that have been
taped do not need to be seam sealed with a liquid sealer unless you want extra protection.
Make sure the seam-sealer is completely dry before re-packing your tent. Damage caused by
misapplication may void warranty.
Zippers
Keeping your zippers clean will help keep the coils and sliders from wearing out. If filled with
dirt, vacuum or brush zippers before storing tent.
Repairs and Warranty
All Big Agnes tents are guaranteed against manufacturing or material defect. We do not war-
ranty products damaged from normal wear and tear, alteration made by owner, misuse, accidents
or damages caused by uses other than intended. Damage due to misuse, normal wear and tear,
or improper care may be repaired at a reasonable charge. Tents returned for repair must be clean
and free of debris.
P.O. Box 773072 • Steamboat Springs, Colorado • 80477
Toll Free: 877.554.8975 • [email protected] • www.bigagnes.com
TENT CARE
Thanks for choosing a Big Agnes tent!
Please feel free to contact us if you have any questions or comments.
[e-mail] or call toll free 877-554-8975
®
Cut here to remove. Do Not Tear!
k
bivysetupinst08 11/8/07 12:23 PM Page 2