Billion BiPAC 8800NL R2 Setup guide

Copyright © 2017 Call Flow Solutions Ltd. All Rights Reserved.
How to Setup Your Billion 8800NLR2
Radio Router
What is in the box?
•1 Welcome letter including a setup guide sent by Call Flow Solutions
•1 Billion 8900NLR2 Router
•1 Power Lead
•1 Yellow Ethernet Lead
•1 Blue Ethernet Lead
•2 Ariel’s
Procedure:
1. Take your router out of the box and connect the power lead to the router, please do
not turn it on until you have all other leads connected.
2. Connect your Blue Ethernet Lead into the blue EWAN port on the back of the router.

Copyright © 2017 Call Flow Solutions Ltd. All Rights Reserved.
3. The blue lead then connects into the IDU’s (Black box labelled Alvarion) Ethernet port
(On the side).
The black lead in the end goes off to the aerial and must be in
the ‘Radio’ port in the end of the IDU.
When fully functional you will have 2 lights on the IDU as
highlighted in the image.
4. If you wish to connect a device hardwired, you will need to use the Yellow Ethernet
Lead provided with the router and connect it to one of the 4 Yellow ETH ports
available.
5. Remove red covers and screw on aerials.
Please Note:
1) The blue Ethernet port labelled EWAN must only be used for the connection to
the IDU.
2) It is recommended that for your main computer you use the main Ethernet
port which is labelled ETH1.