Biocontrol D10G1.1 iMan User manual

Documentation for iMan
www.biocontrol.no
D10G1.1 iMan KeyboardTest Manual
January 2013

Jan-2013 Page 2 of 4 D10G1.1 iMan KeyboardTest Manual
This documentation applies to the product iMan manufactured by
BioControl, Norway.
Documentation version 1.1 completely replaces previous versions.
Modifications since last documentation version:
- none –version 1.0
-version 1.0 - version 1.1
a) small additions
Note:
All information in this document describes product and details ‘as is’.
BioControl can not be held liable for (consequences of) incorrect or
missing information in this document.
Check our website for latest version of this document and information on
this product.

Jan-2013 Page 3 of 4 D10G1.1 iMan KeyboardTest Manual
1. Using application
1) Open KeyboardTest application using the link on the iMan Menu:
2) When application starts, you will see small window titled ”Keyboard Test”:
Now you can press any button on keyboard and it will be shown (along
with its code and modifier key if any was pressed):

Jan-2013 Page 4 of 4 D10G1.1 iMan KeyboardTest Manual
2. Changing keyboard layout
Note: This feature should not be normally used –iMan’s keyboard will be
set to apropriate orientation during production and there is no need
to change it afterwards (unless by mistake).
To switch between keyboard orientations type the following sequence on
numeric keyboard with application in focus:
2, 6, 8, 4, 1, 5, 9
Note: Numeric keyboard can work in two modes: numerical and
alphanumerical. First one is used only for typing numbers, while in
second one you can write all characters just like on mobile phone
keyboard. Before typing mentioned code, make sure that keyboard
is in numerical mode (a small 1 in blue square will be shown on the
taskbar). To change between modes use [Shift] + [Ctrl]
combination.
After you do so, message window should appear:
Changes will take effect after restarting the device.