Biocontrol D10G1.1 iMan User manual

Documentation for iMan
www.biocontrol.no
D10G1.1 iMan BarcodePrinter Manual
January 2013

Jan-2013 Page 2 of 4 D10G1.1 iMan BarcodePrinter Manual
This documentation applies to the product iMan manufactured by
BioControl, Norway.
Documentation version 1.1 completely replaces previous versions.
Modifications since last documentation version:
- none –version 1.0
-version 1.0 - version 1.1
a) small additions
Note:
All information in this document describes product and details ‘as is’.
BioControl can not be held liable for (consequences of) incorrect or
missing information in this document.
Check our website for latest version of this document and information on
this product.

Jan-2013 Page 3 of 4 D10G1.1 iMan BarcodePrinter Manual
1. Printing barcodes
Note: Do not connect printer until application is started and serial port
settings are set properly –due to bad baud rate printer may start
printing junk. When this happen disconnect printer, check serial
port settings and connect it again (with Barcode Printer application
still running).
1) Open Barcode Printer application using the link on the iMan Menu:
2) When application starts, you will window titled ”Barcode Printer”:

Jan-2013 Page 4 of 4 D10G1.1 iMan BarcodePrinter Manual
3) First you might check if serial port to which printer is connected is
properly configured. To do so, click on Printer Settings tab
Usually settings like shown on the picture will be the best choice.
4) To start printing, return to Barcode tab where you can change code type,
its height and width and also caption location (when barcode data will be
printed in ascii text). Be aware that different barcode types have different
requirments for barcode data; most types can use only numeric data with
fixed length.
After typing barcode data, just click on Print button.