Bison PR98SHT User manual

1
P A R T S L I S T
Item Qty Description Item Qty Description
A 1 Steel Backboard** I 2 7/16" X 1 1/2" Carriage Bolt
B 1 Extension Arm** J 2 7/16" Flat Washer
C 2 Parallel Linkage** K 2 7/16" Lock Washer
D 1 Rim** L 2 7/16" Hex Nut
E 1 Steel Board Bracket M 4 3/8" X 1 1/2" Hex Bolt
F 1 Top Pivot Bolt** N 8 3/8" Flat Washer**
G 1 Bottom Pivot Bolt** O 4 3/8" Lock Washer**
**Packaged Separately
H 2 Lock Nut** P 4 3/8" Hex Nutt**
 Inspect all contents prior to installation. Report any missing parts to dealer immediately.
 Read all instructions before proceeding.
—— Instruction Manual ——
PR98SHT, PR98SHTJR AND PR98SXLHT
Bracket to install Steel Backboard on HangTime Systems
Date: 12/21/2017 Rev: I.R. B.A. N.J.C. File: \pub\inst\pr98shtinst Ref#: 920414
Notice:
Follow the instructions provided with the HangTime pole system through instruction #9 to install/
assemble vertical pole and main extension arm assembly. Use these instructions in place of instruction
#10 to install the PR98SHT bracket and steel backboard. Continue with instruction #11 provided with
the HangTime pole system to complete assembly.
Customer Service
[phone]
1. Use Bottom Pivot Bolt (G), Top Pivot Bolt (F) and Lock Nuts (H) to attach Steel Board Bracket (E) to
Extension Arm (B) and Parallel Linkages (C). Do not overtighten hardware, make sure the Extension Arm
(B) and Parallel Linkages (C) pivot and adjust up and down freely. See Figure 1.
2. Hang Steel Backboard (A) over the top lip of Steel Board Bracket (E). Use 7/16"X 1 1/2"Carriage Bolts
(I), 7/16"Flat Washers (J), 7/16"Lock Washers (K) and 7/16"Hex Nuts (L) in the top two holes of Steel
Backboard (A) and Steel Board Bracket (E). Hand tighten hardware at this time. See Figure 1.
3. Use 3/8"X 1 1/2"Hex Bolts (M), 3/8"Flat Washers (N), 3/8"Lock Washers (O) and 3/8"Hex Nuts (P) to
install Rim (D). Hand tighten hardware at this time. See Figure 1.
4. Level Steel Backboard (A) and Rim (D). Tighten all hardware.

2
Figure 1