Bison Fast break User manual

1
P A R T S L I S T
Item Qty Description Item Qty Description
A 1 Back Plate H 1 Return Spring
B 4 5/16” X 2 1/2” Fully Threaded Hex Bolt I 1 Spring Washer
C 8 5/16” Flat Washer J 1 3/8” Hex Lock Nut
D 4 5/16” Flange Nut K 1 Cover Plate
E 1 Rim Assembly L 2 1/4” Self Tapping Screw
F 1 1/2” Pivot Bolt M 1 Net
G 1 1/2” Lock Nut
♦ Inspect all contents prior to installation. Report any missing parts to dealer immediately.
♦ Read all instructions before proceeding.
—— Instruction Manual ——
FAST BREAK
Flex Goal
Date: 3/9/05 Rev: 2 B.A. N.J.C. File: Drive.f\publisher\29jrinst Ref#: 910081
1. Mount back plate (A) to backboard/extension arm with 5/16 X 2 1/2” fully threaded hex bolts (B), 5/16”
flat washers (C) and 5/16” flange nuts (D). Level backboard and back plate (A) prior to tightening
hardware.
2. Install rim assembly (E) to the back plate (A) by feeding the return eye bolt through the clearance hole
shown in figure 1. The back plate (A) and rim assembly (E) are designed to fit tightly together, you may
need to use a soft face hammer to encourage this assembly.
3. Align the pivot bolt holes and install 1/2” pivot bolt (F) through entire assembly, use 1/2” lock nut (G) to
secure pivot bolt. IT IS VERY IMPORTANT THAT THE PAINTED SIDE OF THE LOCK NUT (G)
IS PLACED (STARTED) ON THE PIVOT BOLT (F) FIRST TO PROPERLY LOCK PIVOT
BOLT. Take care not to damage the threads. You may need to tap the 1/2” pivot bolt (F) through the
assembly with a hammer. Tighten bolt and nut, if your assembly does not flex freely loosen 1/2” lock nut
(G)1/2 turn. See Figure 1.
4. Push the front of rim assembly (E) up to seat the assembly in home position, this will facilitate installing
return spring (H), spring washer (I) and 3/8” lock nut (J). Using a 9/16” wrench tighten the 3/8” lock nut
(J) until 2-3 threads are showing below the nut. Spring tension can be adjusted to player preference. See
Figure 1.
5. Install cover plate (K) with 1/4” self tapping screws (L).
6. Install net (M).

2
Rim Assembly (E)
3/8" Hex Lock Nut (J)
Spring Washer (I)
Return Spring (H)
Pivot Bolt Hole
Return Eye Bolt
Back Plate (A)
1/2" Lock nut (G)
Return Eye Bolt Clearance Hole
1/2" Pivot Bolt (F)
5/16" Flat Washer (C)
5/16" X 2 1/2" Fully Threaded Hex Bolt (B)
5/16" Flange Nut (D)
5/16" Flat Washer (C)
(Painted Side In)
Figure 1
IMPORTANT! The painted side of
lock nut (G) must be started first to
properly lock pivot bolt (F).