Bissell Cleanview Passive User manual

Updated by A. Lentz 10/8/2021 P:\Customer Service Dept\Knowledge Base\Troubleshooting\TROUBLESHOOTING GUIDES NEW
MODELS\VACUUM\Troubleshooting 1994F\1994F Blowing Dust.docx
1) Locate post-motor filter on back of vacuum. Press down on filter door tab to
remove door.
2) Clear away any debris build up on and around filter. Reattach filter door.
3) Remove dirt tank by pressing release button and lifting tank away from machine.
Blowing Dust
Cleanview Passive
1994F

Updated by A. Lentz 10/8/2021 P:\Customer Service Dept\Knowledge Base\Troubleshooting\TROUBLESHOOTING GUIDES NEW
MODELS\VACUUM\Troubleshooting 1994F\1994F Blowing Dust.docx
4) Over a trash bin, press empty latch on back of tank to empty tank. Snap shut
bottom lid.
5) Separate top handle from bottom tank by grasping carry handle and base of dirt
tank. Twist the carry handle counterclockwise.
6) Grasp filter handle and lift it out of dirt tank.
7) To separate filter pieces, twist filter handle counterclockwise while grasping base
of outer cyclone.
8) Next, twist filter handle counterclockwise while grasping base of inner cyclone.
Clear away any debris build up. Wash pieces if necessary.
NOTE: DO NOT wash filter. To clean, tap on side of trash bin.

Updated by A. Lentz 10/8/2021 P:\Customer Service Dept\Knowledge Base\Troubleshooting\TROUBLESHOOTING GUIDES NEW
MODELS\VACUUM\Troubleshooting 1994F\1994F Blowing Dust.docx
9) To reassemble, align tabs on filter piece with their mating slots on the inner
cyclone and twist clockwise.
10) Do the same to connect inner and outer cyclone pieces. Reinsert pieces into dirt
tank. Filter should sit level.
NOTE: filter will not sit level if tabs on front are not aligned

Updated by A. Lentz 10/8/2021 P:\Customer Service Dept\Knowledge Base\Troubleshooting\TROUBLESHOOTING GUIDES NEW
MODELS\VACUUM\Troubleshooting 1994F\1994F Blowing Dust.docx
11) Reattach top lid to dirt tank by aligning clear notch with slot on top lid. Clear
notch should point towards unlocked. Twist clockwise to lock.
12) Reattach dirt tank to canister and turn on. If still blowing dust, remove hose to
check for clog.
13) Detach hose from base of canister by pushing on release tab and pulling out.

Updated by A. Lentz 10/8/2021 P:\Customer Service Dept\Knowledge Base\Troubleshooting\TROUBLESHOOTING GUIDES NEW
MODELS\VACUUM\Troubleshooting 1994F\1994F Blowing Dust.docx
14)Detach hose from extension wand by grasping each piece and pulling them
apart. Do the same to detach the foot.
15)Insert broomstick through wand and hose to clear debris.
16)Also, inspect hose section by section for holes or cracks. If a hole or crack is
found,
BISSELL Consumer Care: please refer to product changeover guide.
External Support: Contact BISSELL
17) Reattach pieces by inserting them into their corresponding parts.
18)Turn machine on. If the machine is still blowing dust,
BISSELL Consumer Care: please refer to product changeover guide.
External Support: Contact BISSELL