Bissell CROSSWAVE X7 Guide

CrossWave X7 using the 3-in-1
Docking Station & Clean out Cycle |
Support
The 3-in-1 Docking Station functions as a clean out tray, charging
station, and storage tray for machine, brush rolls, and filter
Clean Out Cycle:
•Plug in the docking station
•Place machine on docking station
•Fill clean water tank with warm tap water and formula to the
clean out cycle icon on the tank
oPut clean water tank back on machine
•Press clean out cycle button and let machine go through full
40 second cycle

oIf machine stops in middle of cycle and orange dirt tank
indicator starts blinking on digital display, remove and
empty dirty water tank
▪Clean out cycle button will be inactive until dirty
water tank is emptied
▪Place empty dirty water tank back on machine,
click clean out cycle button and the clean out cycle
will resume
•If machine does not start the clean out cycle when the
button is pushed, re-seat the machine onto the dock and
allow it to charge for 30 minutes before trying again
•When cycle is complete, remove brush roll window by
pressing the button on the top of the foot and resting the
brush roll window on the 3-in-1 docking station

•Pull up on brush tab to remove brush roll
oPlace brush roll in drying tray to air dry
•Allow filter to dry for 24 hours after cleaning
oPlace filter in drying tray to air dry
•Take machine off docking station

oWipe off any excess water on docking station
oWipe off the charging prongs
•Return machine to docking station
•Empty and clean dirty water tank before storing machine
oFor steps > Go to Dirty Water Tank Maintenance
Charging:

•Make sure charging cord is fully plugged into docking station
oWith adaptor unplugged and machine off docking
station > Flip docking station over
oRemove charging cord from dock and reinstall,
ensuring cord is fully plugged in
•Plug adaptor into wall outlet
•Put machine on docking station
oBattery LED lights will illuminate white while charging
•If lights are not on, remove machine and realign on docking
station
•If one light is blinking white, battery is at less than 10%
•For a full charge allow machine to charge for 4 hours
o3 white lights indicate a fully charged battery when
machine is docked & turned on