Black & Decker SVJ520BFS Dustbuster User manual

www.blackanddecker.co.uk
SVJ520BFS

2
3
1 1413
10
2
3
4
5
5A
6
8
8a
9
12
11
7

3
2
3
1 1413
10
2
3
4
5
5A
6
8
8a
9
12
11
7
1
A
3
3a
B
4
3
C
6
8
D
6
8
17
E

4
8
F
109
11
G
12
H
J
6
5
I

5
7
K L
13
M
14
N

6
610
O
14
P
16
QR

7
ENGLISH
(Original instructions)
Intended use
Your BLACK+DECKER SVJ520BFS Dustbuster® hand-held
vacuum cleaners have been designed for vacuum cleaning
purposes. These appliances are intended for household use
only.
Read all of this manual carefully
before operating the appliance.
Safety instructions
@Warning! Read all safety
warnings and all instructions.
Failure to follow the warnings
and instructions listed below may
result in electric shock, re and/or
serious injury.
uThe intended use is described in this
manual. The use of any accessory
or attachment or the performance
of any operation with this appliance
other than those recommended in this
instruction manual may present a risk
of personal injury.
uRetain this manual for future
reference.
Using your appliance
uDo not use the appliance to pick up
liquids or any materials that could
catch re.
uDo not use the appliance near water.
uDo not immerse the appliance in water.
uNever pull the charger lead to
disconnect the charger from the
socket. Keep the charger lead away
from heat, oil and sharp edges.
uThis appliance can be used by
children aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge
if they have been given supervision
or instruction concerning use of
the appliance in a safe way and
understand the hazards involved.
Children shall not play with the
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
Inspection and repairs
Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts, damage to switches
and any other conditions that may affect
its operation.
uDo not use the appliance if any part is
damaged or defective.
uHave any damaged or defective parts
repaired or replaced by an authorized
repair agent.
uRegularly check the charger lead for
damage. Replace the charger if the
lead is damaged or defective.
uNever attempt to remove or replace
any parts other than those specied in
this manual.
Additional safety instructions
After use
uUnplug the charger before cleaning the
charger or charging base.
uWhen not in use, the appliance should
be stored in a dry place.
uChildren should not have access to
stored appliances.
Residual risks
Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc.

8
ENGLISH (Original instructions)
Even with the application of the relevant
safety regulations and the implementa-
tion of safety devices, certain residual
risks can not be avoided. These include:
uInjuries caused by touching any
rotating/moving parts.
uInjuries caused when changing any
parts, blades or accessories.
uInjuries caused by prolonged use
of a tool. When using any tool for
prolonged periods ensure you take
regular breaks.
uImpairment of hearing.
uHealth hazards caused by breathing
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)
Chargers
Your charger has been designed for a
specic voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
uUse your BLACK+DECKER charger
only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
uNever attempt to charge non-
rechargeable batteries.
uIf the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
uDo not expose the charger to water.
uDo not open the charger.
uDo not probe the charger.
uThe appliance/battery must be
placed in a well ventilated area when
charging.
Electrical safety
Symbols on the charger
Read all of this manual carefully before using the
appliance.
#This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
wShort circuit proof safety isolating transformer. The
mains supply is electrically separated from the
transformer output.
xThe charger automatically shuts off if the ambient
temperature becomes too high. As a consequence
the charger will be inoperable. The charging base
must be disconnected from the mains supply and
taken to an authorised service centre for repair.
$The charging base is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code
+Read all of this manual carefully before
using the appliance
S010Q 23 Only use with charger S010Q 23
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Nozzle
3. Pull out crevice tool
4. Push in brush
5. Handle On/off power switch
5A. Brush control
6. Handle
7. Charging base
8. Chassis
8a. Chassis release button
Use
Switching on and off (Fig. A)
uTo switch on, press the on/off switch (1) located on the
handle of the Dustbuster®, or alternatively on the chassis
handle (5).
uPress the button again (1 or 5), and the unit goes to a
BOOST mode.
uTo switch off, press the on/off switch (1) or (5).

9
ENGLISH
(Original instructions)
Using the pull out crevice tool (Fig. B,C)
uExtend the crevice tool (3) as shown in gure C, until
it clicks in place. The push in brush (4) can be tted if
required for dusting and upholstery cleaning.
uTo retract the crevice tool (3) press the crevice tool release
button (3a) allowing it to return to its normal position
(Fig. B).
Fitting the handle to the main chassis
(Fig. D, E)
uSlide the handle (6) into the main chassis (8) as shown in
gure D.
uSecure with retaining screw (17) as shown in gure E.
Fitting the Dustbuster®to the Chassis
(Fig. F, G, H)
uSlide the Dustbuster® , nozzle rst, into the chassis (8)
until an audible ‘click’ is heard as shown in gure F.
uTo release the Dustbuster®from the chassis press the
chassis release button (8a) and lift clear.
uThe appliance can now be operated via the on/off button
(5) on the handle (6) along with the ‘BOOST’ mode as
shown in gure H. This also allows you to utilise the beater
bars via the ‘brush on’ control (5A).
Removing and clearing the beater bars
(Fig. I, J)
uTo remove the beater bar unit (9) from the oor head (10)
Depress the release button (11) as shown in gure I.
uThe beater bar (12) can now be removed. The end pieces
are also removable allowing you to clear the brushes from
any hair or other debris that may have accumulated (Fig.
J).
Charging (Fig. K, L)
uPlace the appliance into the charging base (7) as shown in
gure K .
uPlug the charging port (7) into an electrical outlet.
uSwitch the electrical outlet on. The LED charging indicator
(B) will Illuminate (Fig. L).
Multi LED Display
A. Filter sensor
Whenever a lter is Blocked and needs cleaning, the red
lter LED (A) in the handle will illuminate.
Clean ne dust from lter (See section on ‘cleaning lters’
in this manual).
B. LED Charging display
Battery icon (B) will illuminate when appliance requires
charging. Led display indicates state of charge (See LED
pattern chart in this manual).
C. BOOST mode
Illuminates when the appliance is in BOOST mode
allowing you to operate at higher power.
LED Patterns
Charging
Battery Fault
Charger Fault
Battery Hot
A
B
C

10
ENGLISH (Original instructions)
Cleaning the lters (Fig. M, N, O, P, Q,
R )
uPress the dust bowl release button (13) (Fig. M)
uEject the dust bowl (14) (Fig.N)
uLift the lter assembly (15) from the dust bowl (14) (Fig.O).
uEmpty the dust bowl by lightly shaking over a dustbin
(Fig. P).
Note: The pre filter is impregnated with a fragrance allowing
for a pleasing odour to be released when the appliance is in
use.
uThe lter (16) can now be removed from the pre lter (15)
Figure Q.
uEmpty any remaining dust from the dust bowl.
uRinse out the dust-bowl with warm soapy water.
uWash the lters with warm soapy water (Fig. R).
uMake sure the lters are dry
uRet the lters onto the appliance.
uClose the dust-bowl. Make sure the release latch (13)
clicks into place.
Warning! Before performing any maintenance or cleaning on
the appliance, unplug the appliance.
From time to time wipe the appliance with a damp cloth.
Do not use any abrasive or solvent-based cleaner. Do not
immerse the appliance in water
Maintenance
Your BLACK+DECKER cordless appliance has been designed
to operate over a long period of time with a minimum of main-
tenance. Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Warning! Before performing any maintenance on cordless
appliances:
uRun the battery down completely if it is integral and then
switch off.
uUnplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
uRegularly clean the ventilation slots in your appliance/
charger using a soft brush or dry cloth.
uRegularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
Replacing the lters
The lters should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement lters are available
from your BLACK+DECKER dealer (cat. no: VPF20). There
are also pre-scented lters available to be purchased (cat.
no: VSPF10LC). These t all units.When these lters reach
the end of their lifespan they must be disposed of at a local
recycling centre.
Warning!
Cotton linen fragrance.
Wash face, hands and any exposed skin
thoroughly after handling. Wear protective
gloves/protective clothing/eye protection/
face protection. If in eyes: Rinse cautiously
with water for several minutes. Remove
contact lenses if present and easy to do.
Continue rinsing. If skin irritation occurs: Get
medical advice/attention. Avoid release into
the environment. Do not ingest.
uRemove the old lters as described above.
uFit the new lters as described above.
Protecting the environment
ZSeparate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be recov-
ered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical Data
SVJ520BFS
Voltage 18V
Watt hours 40Wh
Weight 2.8Kg

11
ENGLISH
(Original instructions)
Guarantee
Black & Decker is condent of the quality of its products and
offers an outstanding guarantee. This guarantee statement is
in addition to and in no way prejudices your statutory rights.
The guarantee is valid within the territories of the Member
States of the European Union and the European Free Trade
Area.
If a Black & Decker product becomes defective due to faulty
materials, workmanship or lack of conformity, within 24
months from the date of purchase, Black & Decker guarantees
to replace defective parts, repair products subjected to fair
wear and tear or replace such products to ensure minimum
inconvenience to the customer unless:
uThe product has been used for trade, professional or hire
purposes;
uThe product has been subjected to misuse or neglect;
uThe product has sustained damage through foreign
objects, substances or accidents;
uRepairs have been attempted by persons other than
authorised repair agents or Black & Decker service staff.
To claim on the guarantee, you will need to submit proof of
purchase to the seller or an authorised repair agent. You can
check the location of your nearest authorised repair agent by
contacting your local Black & Decker ofce at the address indi-
cated in this manual. Alternatively, a list of authorised Black &
Decker repair agents and full details of our after-sales service
and contacts are available on the Internet at: www.2helpU.
com
Please visit our website www.blackanddecker.co.uk to register
your new BLACK+DECKER product and to be kept up to
date on new products and special offers. Further information
on the BLACK+DECKER brand and our range of products is
available at www.blackanddecker.co.uk

90633712 REV-0
12/2015
Australia Black & Decker (Australia) Pty. Ltd. Tel. [phone]
20 Fletcher Road, Mooroolbark, Fax [phone]
Victoria, 3138
New Zealand Black & Decker Tel. [phone]
5 Te Apunga Place Fax [phone]
Mt Wellington
Aukland 1060
United Kingdom & Black & Decker Tel. [phone]
Republic Of Ireland 210 Bath Road Fax [phone]
www.blackanddecker.co.uk Slough, Berkshire SL1 3YD
[email protected]