Blackline Safety G6 User manual

G6 GETTING STARTED GUIDE
©2023 Blackline Safety Corp G6 Getting Started Guide |1
Rev. 01 2023-05-15
OVERVIEW
G6 is a portable single-gas detector manufactured by Blackline Safety, providing up to one year of
maintenance free operation. G6 supports the detection of CO, H2S, O2, or SO2.
G6 HARDWARE
FRONT
BACK

G6 GETTING STARTED GUIDE
©2023 Blackline Safety Corp G6 Getting Started Guide |2
Rev. 01 2023-05-15
G6 SCREENS
HOME SCREEN
STATUS SCREENS
OK status
G6 has no active
notifications that
require attention.
Low urgency
status
G6 has active low
urgency or
operational
notifications that
require attention.
High urgency status
G6 has active high urgency notifications that require immediate
attention/interaction.

G6 GETTING STARTED GUIDE
©2023 Blackline Safety Corp G6 Getting Started Guide |3
Rev. 01 2023-05-15
G6 FUNCTIONALITY
ACKNOWLEDGING NOTIFICATIONS
To allow you to read and understand notifications, there is a 2-second delay on your ability to
acknowledge full screen notifications.
To acknowledge operational and low
urgency notifications, select by pressing
the center button.
To acknowledge high urgency notifications,
immediately evacuate the area and follow
your emergency safety protocol. When you
are safe, read G6’s screen and select by
pressing the center button.
If the event persists longer than 60 seconds,
the notification will reactivate.
BUMP TESTING AND CALIBRATING
To manually bump test and calibrate G6, you
will need a calibration cap (ACC-G6-CAL) and
tube (ACC-G6-T2). You can also bump test and
calibrate using G6 Dock.
1. Attach the tubing to the calibration
cap. Ensure the other end of the
tubing is attached to a fixed flow
regulator on the gas tank. Do not turn
on the gas cylinder until G6 indicates
you should do so.
2. From the Home screen, select by
pressing the center button.
3. Using the navigation buttons, scroll
through the Global Navigation menu
and select Compliance ( )by pressing
the center button ( ).
4. To access the available Compliance
procedures, select by pressing the
right button.
5. Using the navigation buttons, scroll to
and select Bump test or Calibration
by pressing the center button ( ).
6. Follow the screen prompts to
complete the test.
VIEWING PEAK AND STEL VALUES
You can view peak and STEL readings through
the Gas options feature:
1. From the Home screen, select by
pressing the center button.
2. Using the navigation buttons, scroll
through the Global Navigation menu
and select Gas options ( )by
pressing the center button ( ).
For detailed information on G6, see our
G6 Technical User Manual.
TECHNICAL SUPPORT
North America (24 hours)
Toll Free: 1-877-869-7212 |[e-mail]
United Kingdom (8am-5pm GMT)
[phone] |[e-mail]
International (24 hours)
[phone] |[e-mail]