BLAUBERG Ventilatoren SGS E1 User manual

Sensor speed controller
SGS E1/SGS E2.5
The sensor thyristor speed controller SGS E1/SGS E2.5 is designed for output power of ventilation units
and domestic fans as well as their turning on and off. The speed controller is equipped with a sensitive
sensor panel made of hardened glass, with the button and two buttons for speed control from
minimum ( ) to maximum value ( ).
WARNING! Make sure that the speed controller is not damaged. Do not operate a damaged speed controller! Do not install the speed controller
on an uneven surface! Do not apply excessive forces to avoid the product deformation.
Mounting sequence of the sensor speed controller:
Unfasten gently the front panel latches of the speed controller.
Remove the front panel.
Route the cable in the wall to the panel mounting place.
Attach the back panel to the wall or in the mounting box through the mounting holes.
Install the front panel on the latches.
86
62
4
52
86 31
21
R1.5
11
58
Sensor speed controller mounting
OVERALL AND CONNECTING DIMENSIONS
WIRING DIAGRAM
TECHNICAL DATA
MOUNTING
SGS E1 SGS E2.5
Power supply voltage [V] 230/50-60
Maximum load current [A] 1 2.5
Cable cross section [mm²] from 0.35 up to 1 from 0.75 up to 1
Temperature range [°C] from -10 up to +45
Humidity range [%] 5-80 (no condensation)
Service life 100 000 switching operations
Ingress Protection Rating IP30
Weight [g] 138
WARNING! Disconnect the speed controller from power supply prior to any maintenance operations.
All work related to mounting, amendments, modification and maintenance may only be carried out by qualified personnel with
work permit for electric operations.
DESCRIPTION
EN

Speed controller operation
WARRANTY
B95EN-03
Operation Key
When connected to power mains the button has blue soft light
To turn ventilation equipment on press the button
To turn ventilation equipment off press the button
To decrease ventilation equipment speed press the button
To increase ventilation equipment speed press the button
Minimum speed setting:
1. Press and hold the button for about 5 seconds until the indicator shows about 50 % of the operating
speed range (that helps distinguish the setup mode from the operating mode). The ventilation
equipment will operate with maximum speed
2. Set minimum speed:
To set speed up press the button
To set speed down press the button
The set speed level is displayed on the LED indicator
To save set point press the button
To turn the fan on and to activate its operation in set mode press the button
The minimum speed set point will be saved
Every time you enter the set up mode the previous minimum fan speed is set as 100 % of the total capacity by default.
CONTROL
There are two modifications of the speed controller casing. The wiring diagrams (depending on the casing modification) are provided below.
L
N
2.5
NLL1L3 L2E
230 V,
50/60 Hz
L
N
OUTOUT OUTOUT IN
LL1L2L3L4
230 V,
50/60 Hz
Wiring diagram (SGS E1 and SGS E2.5) Wiring diagram (only for SGS E1)
Unit Type Sensor speed controller
Seller’s Stamp
Model SGS E ____
Serial Number
Manufacture Date
Purchase Date
Warranty Period
Seller