1. Lid2. Internal removable water tank3. Heater4. Sponge disc5. Steam tunnel6. Acoustic overlay7. Housing8. Drawer with aromatherapy attachment9. Control panel buttons a) power switch b) humidification intensity c) timer / ionization d) auto / night mode e) humidistat f) cleaningPREPARING THE APPLIANCE FOR OPERATIONBefore starting the appliance, it is recommended to familiarise yourself with its components.Ensure that the sponge disc is placed on the heater. Make sure that the acoustic overlay is positioned and closed (by turning the element). Check whether the steam tunnel is fitted. Remove all foils, cartons and protective tapes from the appliance.FILLING THE WATER TANKThere are two methods of filling the tank.1. After removing the tank lid (1), pour water into the tank using a bottle or other vessel.2. After removing the lid (1), you can take out the tank (2). Lift the tank with the handle. Fill the tank under the tap. Put the tank in the appliance body noting the position of the internal components.USING THE APPLIANCEPress the power switch (9a) to turn on the appliance. After pressing the power switch, the humidifier will start to warm up. The water will start to evaporate under the influence of temperature. The evaporation intensity depends on the selected level of humidification intensity. Pressing the button again will make the appliance return to standby mode.The display shows the humidity level and the ambient temperature. Due to the heating of the body, while not maintaining sufficient air flow, the temperature indications may differ from the actual ones. In addition, the display indicates the humidification intensity (one, two or three bars) and whether the ionization function is active.The humidification intensity can be adjusted using 3 intensity levels. Set the intensity by pressing the humidification intensity selection button (9b). At higher humidification intensity, the heater uses more power, a larger part of the water volume boils (the lower the efficiency, the quieter the appliance works).Press the humidistat setting button (9e) to enable the Humidistat mode. Each press will change the target ambient humidity value by 5%. The air humidifier will turn on and off to maintain humidity within the selected humidity level. Press the auto button (9d) to enable the auto mode. The humidifier will try to maintain the air humidity in the range of 50%-60% by choosing the appropriate humidification intensity.To turn off the air humidifier lighting and enable the night mode, press and hold the night mode button (9d). Pressing any button will restore the display.In order to set the appliance turn-off timer, press the timer button (9c) to start the timer; each press sets the time to the appliance turn-off from 1 to 10 hours. A long press of the button (3 seconds) activates or deactivates the ionization function.High efficiencyAverage efficiencyLow efficiency400 W300 W150 W500 ml/h300 ml/h150 ml/hAHM7016
