Bliss HCS-499 User manual

½”
PART A - BASE HALF
PART B - BASE HALF
HAMMOCK CHAIR STAND - ASSEMBLY
HARDWARE INCLUDED (TOTAL OF 9) PARTS INCLUDED (TOTAL OF 4)
(2) 3⅛” Screws
(2) Washers (2) Nuts
TOOLS INCLUDED (TOTAL OF 2)
TOOL REQUIRED
BUT NOT INCLUDED
Assembling Your Hammock Chair Stand:
TWO PEOPLE ARE REQUIRED TO SET UP THE HAMMOCK CHAIR STAND.
(1) Align PART A - BASE HALF with PART B - BASE
HALF placing them ½” apart.
WARNING: MAKE SURE THE ENTIRE BASE IS SECURE
TO THE GROUND BEFORE PROCEEDING.
(2) Have one person hold PART C,while placing it via its
protrusion into the circular opening between the base halves
(PART A & PART B).
(2) 1⅛” Screws (1) Carabiner Hook
(1) Allen Wrench (1) Open-End Wrench
HAMMOCK CHAIR STAND - ASSEMBLED
PART A - BASE HALF
PART B - BASE HALF
PART C
PART D
Protrusion of PART C
circular opening
PART A
PART B
[TOP VIEW]
[TOP VIEW]
(1) Hammer

HAMMOCK CHAIR STAND - ASSEMBLY
Hammock Chair Installation
(Hammock Chair Sold Separately)
WARNING: TIPPING HAZARD
MAKE SURE THE ENTIRE BASE
IS SECURED TO THE GROUND
BEFORE USE.
(3) While holding PART C in place, the other person will take
the (2) 3⅛” Screws and thread it through each of the holes
on one side of the base. Place a Washer and then a nut on
each of the screws. Hold the nut in place using the
Open-End Wrench while using the Allen Wrench to tighten
the screws.
(4) Use the Allen Wrench to
tighten the (2) 1⅛” Screws to
screw in PART D into PART C.
(5b) When installing the Hammock Chair, latch the
Hammock Chair loop into the opening of the Carabiner
Hook. Use a hammer to gently tap the top of the
Hammock Chair loop until it is securely in place and
the Carabiner Hook gate snaps closed.
For best results, secure base using nails (or
metal stakes) with a head that is greater
than ½” and body that is less than ½”;
inserted through the holes at the ends of
the base.
WEIGHT CAPACITY: 300 LBS
PART C
[TOP VIEW]
PART D
PART C
(5a) Take the Carabiner Hook and latch it onto the loop that
is on PART D. Rotate the hook such that the narrow end
meets with the loop and pull downward. Use a hammer to
lightly tap the hook until it is securely on the loop.
FULLY ASSEMBLED
HAMMOCK CHAIR & HAMMOCK CHAIR STAND