Blodgett XR8-G User manual

BLODGETT OVEN COMPANY
www.blodgett.com
44 Lakeside Avenue, Burlington, VT 05401 Toll Free: [phone] • Phone: [phone] • Fax: [phone]
EXTERIOR CONSTRUCTION
Fully welded angle iron frame
Double pane tempered glass doors
Semi-rigid mineral fiber insulation at top, back, sides and bottom
Removable independent door design
Control panel rotates out for easy access
INTERIOR CONSTRUCTION
304 stainless steel interior
Rotating rack can be removed without tools
Rack slide spacing can be adjusted without tools in any configuration
using 1” increments.
Stainless steel heat exchanger system
Four side mounted halogen lights for superior illumination
OPERATION
Indirect-fired with in-shot burners
Internal steamer system
Holds 8 pans (18” x 26”) based on 4” adjustable slide spacing
Digital programmable controls
Separate bake and steam times
Cool-down mode
Blower delay
Single speed, 1/4 horsepower, convection motor with automatic thermal over-
load protection
STANDARD FEATURES
Pre-plumbed gas and water lines
12 pan stand with adjustable spacing, removeable crumb trays and low profile
casters
Two year parts and one year labor oven warranty*
* For all international markets, contact your local distributor.
OPTIONS AND ACCESSORIES
(AT ADDITIONAL CHARGE)
Gas hose with quick disconnect and restraining
device:
48" (1219mm) hose
36" (914mm) hose
Venting
Draft diverter
Draft hood
VFD control can hold multi-stage programming for
up to 100 products
Additional rack slides
Wire rack for half-size pans
XR8-G
Gas Mini Rotating Rack Bakery Oven
XR8-G ROTATING RACK OVEN
Project
Item No.
Quantity
Refer to operator manual specification chart for listed model names.
XR8-G with 12 pan stand

BLODGETT OVEN COMPANY
www.blodgett.com
44 Lakeside Avenue, Burlington, VT 05401 • Toll Free: [phone] • Phone: [phone] • Fax: [phone]
XR8-G Rotating Rack Oven
SHORT FORM SPECIFICATIONS
Provide Blodgett gas mini rotating rack bakery oven model XR8-G. Unit shall have a single compartment with fully welded angle iron frame, and 304 stainless steel interior. Unit shall accept
eight I8" x 26" standard full-size bake pans and have rack slides with spacing that can be adjusted without tools in any configuration using 1” increments. Rotating rack shall be remov-
able without tools. Unit shall have stainless steel front, top and sides. Doors shall be stainless steel, independent design with dual pane thermal glass windows. Unit shall be gas heated
with electronic spark ignition and shall cook by means of indirect fired inshot burners. Unit shall have internal steamer system with pre-plumbed water lines. Unit shall be fitted with four side
mounted, halogen lamps. Control panel shall be digital programmable controls, separate bake and steam times, cool-down mode, and blower delay. Manual gas service cut-off switch on
front panel. Two year oven parts and one year labor warranty. Provide options and accessories as indicated.
DIMENSIONS:
Floor space 48.23” (1225 mm) W x 40.27” (1023 mm) D
Interior 32” (813 mm) W x 32” (813 mm) D
Product clearance
0" from combustible and non-combustible construction
GAS SUPPLY:
3/4" NPT
Manifold Pressure:
• Natural – 3.5" W.C • Propane – 10" W.C.
Inlet Pressure:
• Natural – 5.0" W.C. min. – 14.0" W.C. max.
• Propane – 11.0" W.C. min. – 14.0" W.C. max.
MAXIMUM INPUT:
XR8-G 110,000 BTU/hr
POWER SUPPLY:
XR8-G 120V, 60Hz, 1 phase, 15 amp maximum dedicated circuit
COLD WATER SUPPLY:
Pipe Size 3/4” GHT
Pressure 30-75 psi. (21-52 kPa) minimum
Flow Rate 1.12 gal/min (4.5 liters/min.)
DRAIN:
XR8-G 3/4” NPT rear drain connection
MINIMUM ENTRY CLEARANCE:
Uncrated* 33" (838 mm)
Crated 49.25" (1251mm)
* Unit will fit through standard 36” door with the doors, control panel, and back
panel removed.
SHIPPING INFORMATION:
Approx. Weight:
XR8-G 950 lbs. (431 kg)
Stand 119 lbs. (54 kg)
Crate sizes:
XR8-G 49.25" (1251mm) x 54.25" (1378mm)
Stand 54” (1371mm) x 34” (864mm) x 24” (610mm)
Printed in U.S.A. NOTE: FOR COMMERCIAL USE ONLY
NOTE: The company reserves the right to make substitutions of components without prior notice
DIMENSIONS ARE IN INCHES (MM)
W
D
EXHAUST
2.78 (71)
53.03
(1347)
8.53 (217)
14.43 (367)
5.45
(138)
TOP VIEW
48.23 (1225)
0
32.60 (828)
37.83 (961)
47.44 (1205)
28.32 (719)
40.27 (1023)
SIDE VIEW
D
W
75.53 (1918)
26.03 (661)
APPROVAL/STAMP
P/N 38481 Rev J (3/08)