BLOTZ B20-ST-111 Instructions for use

20mm Pissoir and Benches
B20-ST-111
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
The central column starts with the pieces shown
above. Note the small hexagon and the “cog” are the
same size.
Glue the two larger hexagons together and insert
the spindle through both pieces. To ensure pieces
are the right way round make sure the sprue points
are on the same side.
Next glue the “cog” into place. Then attach the arms so that the long edge is resting
on the base as shown.
Lock these into place by adding the small hexagonal
piece (again ensure you align the sprue point).
Glue the remaining hexagons onto the spindle.

Next remove the six strips from the sprue.
Attach the two largest hexagons to the spindle and
top these with the small hexagons. Glue one strip to
the centre of each side of the column as shown.
Remove the six oblongs and their frames from the
sprue.
Glue an oblong to each of the arms with the hole
towards the bottom (see above).
Glue a frame to each oblong.
Each of the long walls is formed from the pieces
shown above.
Glue these together as shown so the etched detail is all
on the outer face.
The two smaller walls use these pieces.
And go together as above. Attach the walls to the base using the holes
provided.

Finally glue the central column into place using the
hexagon on the base as a guide.
Each bench is formed from the four pieces shown.
Note the lug on the “back” is not central.
Glue the base and back to one end piece.
Then glue the other end into place.