BLOTZ B28-OW-203 User manual

28mm Privy #1
B28-OW-203
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the base and front of the seat from the sprue.
Glue together as shown above.
Take the back wall and seat upper.
Glue the seat upper to the reverse of the back wall.
Check the detailing is facing the right way (see pic).
Glue the back wall to the base.
Carefully insert the door handle into the space in the
door. Leave to dry.
Take the front wall from the sprue.
Glue it to the base as shown.

The two side walls…
.. are then glued into position –high edge towards
the front of the privy..
The door, upper support and rear piece.
Place the upper support on top of the door, then
insert the lower peg of the door into the hole in the
base. Gently slide the upper support into the gap
provided (see pic).
The upper support should end up flush with thje front
of the privy as shown above.
Glue the rear piece to the back of the front wall, so
it helps to hold the upper support in place.
The roof and door frame.
Glue these into place. The roof should extend out
more forwards than backwards.
The completed privy.