BLOTZ B06-MW-100 User manual

6mm 3x2 Shops Foyer
B06-MW-100
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Foyer (B06-MW-100)
Start by removing the short sides from the sprue
along with the two bracers.
Glue the bracers bar to the back of the short side
positioned using the lugs provided.
Attach the long sides so that both the side lugs
and bracer lugs fit into the holes provided.
This will give you a hollow box shape.
Attach the columns and balconies to the long
sides as shown above.
Then attach the columns and balconies to the short
sides.

6mm 3x2 Shops Middle (Broken)
B06-MW-1 3
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Middle (Broken) Section (B06-MW-1 3)
Take both floor sections and one end from the
sprue.
Glue the floors into position (to
the back of the wall) using the
lugs provided. The etched detail
should be facing upwards
Move around the building gluing the walls into
position as shown above.
Glue the supports into position behind each wall.
Finally glue the balconies into position.