BLOTZ B28-ME-009 User manual

28mm Middle Eastern Building #9
B28-ME-009
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the three pieces shown above from the
sprue.
Glue them together as shown above.
Take this long wall section.
And glue it to the first set of walls.
Take these two walls.
Glue them together as shown.
Take these three pieces
And glue them together.

Take these two pieces
Glue them together.
You should now have the four sub-assemblies shown
above. Attach the two left-hand side sub-assembles
together, then add the right-hand one. Finally add the
top one.
Attach the walls to the base pieces.
Take the roof supports as shown above.
Glue them into place so that they extend through
the wall (see pic.)
Glue the door into position.
Take the arch and door pieces.
Place the lower lug of each door into the hole in the
base. Slip the crossbar over the upper lugs, then
gently move it into the slot at the top of the inner
arch. It will stick out front and back by about 3mm.
Glue an arch piece in front and behind the main
archway.

Place (do not glue) the roof sections into position,
then glue the trapdoors to them.
The completed building.