BLOTZ Future Gothic B08-FG Series User manual

Future Gothic Components
B08-FG-xxx
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue.
Please use knives with due care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
These instructions cover all the components which form part of our Future Gothic range.
Walls / Windows
Each wall / window is formed from two pieces as
shown above.
Glue the base to the bottom of the wall / window.
To create multiple layers, simply slot the top window
on to the bottom window.
Tall Columns
Each large column is formed from the pieces shown
above.
Glue two of the inner supports in place.

Attach the other three sides.
Glue the end cap in place.
Short Columns
Each short column is formed from the pieces shown
above.
Glue one of the inner supports in place.
Attach the other three sides.
Glue the end cap in place.
Edge Strips / Buttress
Take the strip / buttress…
And slot it into the hole(s) in the column.
Flying Buttress
Take the four pieces shown on the left.
Glue the base in position.
Attach the side pieces.
Slot the flying buttress into the holes in the column.

Upper Floors
Locate a suitable floor section.
Check that the ledges it will be glued to are clear of
dried glue / debris.
Glue it into position on top of the ledges.