BLOTZ B28-SF-228 User manual

28mm Walkway –Triple
B28-SF-228
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Front A - Open
Take the two pieces shown above from the sprue.
Glue the one on the left to the back of the one on
the right.
Take the barricade section…
..and glue it into position (see pic). Leave to dry.
Front B –Firing Point (do this twice)
Take the two pieces shown above from the sprue.
Glue the one on the right to the back of the one on
the left.

Take the lower barricade section…
..and glue it into position (see pic).
Take the upper barricade section…
..and attach that to the model as shown.
The rear barricade section.
Glue this into place. Leave this “front” assembly to
dry.
Rear Supports (Do this three times)
Take the pieces shown above from the sprue.
Glue the one on the left to the back of the one on
the right. Leave to dry.
Final Assembly
Take the six sub-assemblies you have made.
Glue the three “front”pieces to the walkway.

Attach the three “rear”pieces to the walkway.
Take the six cross-braces.
Attach each cross-brace between the front and rear
supports using the lugs.
Glue the whole model to the base.
Take the armour plates.
Glue them into position as shown above.
The finished model.